Alcatel 5081, 5101, CFV 100, 5081 CP IS, Turbo Pump, Turbopack ...

51
The remote control plug P2 can be used for the following functions:
- Connection of outer safety switch opens when a malfunction apears.
- Remote control from starting or stopping of the TMP motor (start and stop in front panel).
- We advise to screen the remote control cable.
See figures 6/2 and 6/3 - P2 plug connection.
Interface output J6 : see figure 6/4 at the end of the manual.
Note: If an electromagnetic valve is utilized on the same vacuum system as the turbomolecular pump then
the valve must have a shielded cable. The shielded cable must properly grounded. This precaution must be
followed to prevent interference with the TMP frequency converter.
3.4 - STARTING
I
For a new TMP, or after two months, we advise the user that switch 110nl1 the TMP at atmospheric pressure
for about 5 minutes with converter (it is necessary for a repartition of grease in ball bearings).
062794 • 10/1993