What is the Sequencer Object? - Platforma Internetowa ASTOR

24 Chapter 2 Defining Steps
2 Click the + button next to Steps. A template line is added
to the step program.
Configuring Steps
Configuring a step tells the step program what to do when
this step becomes active. You can configure the following:
Step Name
Step Section
Condition
Trigger
Timer Preset
Write On Exit
Jump Section
Condition
Trigger
Timer Preset
Arbitrary name you can use for easier
identification.
The combination of a trigger and/or timer
required for the step to be executed. The
condition is evaluated at each scan cycle
until the condition is fulfilled, or any other
action is taken.
The trigger that is associated with the
condition. The trigger is represented by an
Alias which is defined in the Aliases
panel.
The time setting that is associated with
the step condition. This can either be an
actual time or an offset.
Determines whether the step program
writes the On Exit values to the outputs
when the step condition is met.
The combination of a trigger and/or timer
required for Sequencer to jump to a
different step. The jump condition is
evaluated at each scan cycle. It causes
Sequencer to jump, if the jump condition
is met.
The trigger that is associated with the
condition. The trigger is represented by an
Alias which is defined in the Aliases
panel.
The time setting that is associated with
the jump condition. This can either be an
actual time or an offset.
Sequencer Object User’s Guide