What is the Sequencer Object? - Platforma Internetowa ASTOR

40 Chapter 3 Defining Step and Jump Conditions
To configure a step with a monthly timer
1 Click the Step Program tab. The Step Program panel
appears.
2 Locate the step for which you want to change the step
condition or jump condition.
3 Click the Condition cell or Jump Condition cell of that
step and select Cyclic Timer Month.
4 Click on the Step Timer Preset or Jump Timer Preset cell
near the condition cell.
5 Click the Browse button. The Cyclic Timer Month dialog
box appears.
6 Select the activation time from the pulldown menus and
click OK.
Note In the Timer Preset field the value for Day is calculated as
day of month - 1. For example: The 5th day of the month appears
as 04:00:00:00 in the Timer Preset Field.
Important Specifying an offset of days greater than or equal to
the number of days in the current month causes the event to fire
on the last day of the month. However, if the step is entered on
the last day of the month and exceeds the timer preset, the value
does not fire in this month. For example: An activation time of
30:5:15:10 entered on February 28 at 6:00AM (non leap year) does
not fire in February because it exceeds the preset time of 5:15:10.
In this scenario, the event triggers on March 31 at 5:15:10.
Defining Steps with Weekly Timers
You can use weekly timers to fulfill a step condition or jump
condition once a week. You can specify at what time precisely
you want the step condition or jump condition to be fulfilled.
To configure a step with a weekly timer
1 Click the Step Program tab. The Step Program panel
appears.
2 Locate the step for which you want to change the step
condition or jump condition.
3 Click on the Condition cell or Jump Condition cell of that
step and select Cyclic Timer Week.
Sequencer Object User’s Guide