What is the Sequencer Object? - Platforma Internetowa ASTOR
What is the Sequencer Object? - Platforma Internetowa ASTOR
What is the Sequencer Object? - Platforma Internetowa ASTOR
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
42 Chapter 3 Defining Step and Jump Conditions<br />
Tip In <strong>the</strong> Timer Preset cell, you can enter <strong>the</strong> activation time in<br />
xx:hh:mm:ss (xx=ignored, hh=hours, mm=minutes, ss=seconds).<br />
Defining Steps with Hourly Timers<br />
You can use hourly timers to fulfill a step condition or jump<br />
condition once an hour. You can specify at what time<br />
prec<strong>is</strong>ely you want <strong>the</strong> step condition or jump condition to be<br />
fulfilled.<br />
To configure a step with a hourly timer<br />
1 Click <strong>the</strong> Step Program tab. The Step Program panel<br />
appears.<br />
2 Locate <strong>the</strong> step for which you want to change <strong>the</strong> step<br />
condition or jump condition.<br />
3 Click on <strong>the</strong> Condition cell or Jump Condition cell of that<br />
step and select Cyclic Timer Hour.<br />
4 Click on <strong>the</strong> Step Timer Preset or Jump Timer Preset cell<br />
near <strong>the</strong> condition cell.<br />
5 Click on <strong>the</strong> ellips<strong>is</strong>. The Cyclic Timer Hour dialog box<br />
appears.<br />
6 Enter <strong>the</strong> activation time and click OK.<br />
Tip In <strong>the</strong> Timer Preset cell, you can enter <strong>the</strong> activation time in<br />
xx:xx:mm:ss (xx=ignored, mm=minutes, ss=seconds).<br />
Defining Steps with Minute-Based Timers<br />
You can use minute-based timers to fulfill a step condition or<br />
jump condition once a minute. You can specify at what time<br />
prec<strong>is</strong>ely you want <strong>the</strong> step condition or jump condition to be<br />
fulfilled.<br />
To configure a step with a minute-based timer<br />
1 Click <strong>the</strong> Step Program tab. The Step Program panel<br />
appears.<br />
2 Locate <strong>the</strong> step for which you want to change <strong>the</strong> step<br />
condition or jump condition.<br />
<strong>Sequencer</strong> <strong>Object</strong> User’s Guide