What is the Sequencer Object? - Platforma Internetowa ASTOR

38 Chapter 3 Defining Step and Jump Conditions
Data Change
4 Click the Trigger cell to the right of the step condition cell
or jump condition cell.
5 From the list, select the Alias you want to use as a trigger
or enter and define a new Alias.
Defining Steps with Timers
You can configure a step with a timer that only delays step
execution. This timer is called a Simple Timer. You can use
the Simple Timer to make Sequencer wait a certain time
period before writing values to the On Exit outputs.
Tip In the Timer Preset cell, you can enter the time delay in
dd:hh:mm:ss (dd=days, hh=hours, mm=minutes, ss=seconds).
Note The time format in the Sequencer editor is dd:hh:mm:ss
does not correspond to the ElapsedTime format of the equivalent
attribute (such as seen in Object Viewer), which is “d hh:mm:ss”.
To configure steps with a simple timer
1 Click the Step Program tab. The Step Program panel
appears.
2 Locate the step for which you want to change the step
condition or jump condition.
3 Click the Condition cell in the Step section or Jump
section for that step and select Simple Timer.
4 Click the Timer Preset cell to the right of the condition
cell.
5 Click the Browse button. The Simple Timer dialog box
appears.
6 Configure the timer and click OK.
Sequencer Object User’s Guide