Download Seagull Mustang Instruction Manual - Green Hobby ...
Download Seagull Mustang Instruction Manual - Green Hobby ...
Download Seagull Mustang Instruction Manual - Green Hobby ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MUSTANG P-51.<br />
<strong>Instruction</strong> <strong>Manual</strong>.<br />
ELEVATOR - RUDDER PUSHROD INSTALLATION.<br />
! 1) Elevator and rudder pushrods assembly<br />
follow pictures below.<br />
Switch.<br />
Elevator.<br />
Pushrod.<br />
Control horn.<br />
Throttle.<br />
Rudder.<br />
Elevator.<br />
M2 lock nut.<br />
! 2) Connect the elevator and rudder servos<br />
to your radio’s receiver and turn on the system.<br />
Set the trim tabs on the transmitter to<br />
neutral and center the servo arms. The elevator<br />
and rudder servo arms should be perpendicular<br />
to the servos.<br />
MOUNTING THE TAIL WHEEL BRACKET.<br />
3mmX12mm.<br />
! 3) One at a time, hold the pushrods in position<br />
over the respective servos to check for<br />
proper servo direction. If any servo turns in<br />
the wrong direction, switch your radio’s reversing<br />
switches as necessary to achieve the<br />
correct direction.<br />
! 1) Set the tail wheel assembly in place on<br />
the plywood plate. The pivot point of the tail<br />
wheel wire should be even with the rudder<br />
hinge line and the tail wheel bracket should<br />
be centered on the plywood plate.<br />
! 2) Using a pen, mark the locations of the<br />
two mounting screws. Remove the tail wheel<br />
bracket and drill 1mm pilot holes at the locations<br />
marked.<br />
! 3) Secure the tail wheel bracket in place<br />
using two 3mm x 12mm wood screws. Be<br />
careful not to overtighten the screws.<br />
22