Tracer Interpretation Using Temporal Moments on a Spreadsheet G

More documents

Recommendations

Info

<strong>Tracer</strong> <strong>Interpretation</strong> <strong>Using</strong> <strong>Temporal</strong> <strong>Moments</strong> on a Spreadsheet 1. INTRODUCTION This document describes a spreadsheet application for tracer test analysis. The analyses are based on the first temporal moment of a tracer. The governing equations are briefly discussed, and the individual steps required of the user are outlined. A series of Excel macros written in Visual Basic calculate mean residence time, swept pore volume, and flow-storage geometry from a tracer history. The user is directed to the literature cited for more information on the interpretation methodology. 1.1 Background and Motivation The importance of tracer testing is indicated by the more than 100 geothermal tests conducted worldwide in the last 40 years. a Some workers have used tracer tests to constrain numerical models, using the data to estimate heat transfer parameters (e.g., Robinson and Tester 1984; Axelsson et al. 2001), or to constrain reservoir-scale numerical models (e.g., Gunderson et al. 2002; Bloomfield et al. 2003). However, the vast majority of these tests were interpreted qualitatively, ignoring the temporal evolution of the tracer breakthrough curve and resulting in gross test interpretation (e.g., size of the arrow indicative of relative tracer flow). This document discusses a means of extracting useful, quantitative information from tracer testing. A host of tracer test analysis methods consider the temporal behavior of tracers. The methods were originally developed for closed reactor vessels (Danckwerts 1958; Levenspiel 1972), but have been applied to more general conditions of open boundaries (Pope et al. 1994), characterization of fractured media under continuous tracer reinjection (Robinson and Tester 1984), and estimates of flow geometry (Shook 2003). These methods have a rigorous mathematical basis and offer additional information about the subsurface. The analysis is useful independently, but also can be used to constrain numerical models by defining interwell volume and flow geometry. The methods and applications mentioned above are all based on analysis of tracer residence times. The mean residence time, or first temporal moment, is the most useful single property derived from a tracer test, although other properties have been used as well. Levenspiel (1972) shows the total pore volume swept by a tracer can be determined from its mean residence time. Certain restrictions are inherent in the calculation; for example, steady state conditions and conservative tracer behavior. Nevertheless, the method has a rigorous mathematical basis and has been extensively validated analytically and experimentally. The governing equations used in moment analysis are as follows. Terms are defined in the Nomenclature. t * 0 0 E(t)tdt E(t)dt (1a) V p m M inj qt * (1b) a M. Adams, University of Utah, personal communication. 1
The means by which individual terms in these equations are estimated from tracer analysis are discussed in the following sections. This discussion is somewhat brief, since the literature cited addresses the method in great detail. The second part of this document summarizes the individual steps required of a user to perform the interpretation using this spreadsheet application, and includes an example analysis. 2
Page 1 and 2: INL/EXT-05-00400 Tracer</st
Page 3 and 4: NOTICE This computer software was p
Page 6: ACKNOWLEDGMENTS The authors thank t
Page 9 and 10: viii
Page 14 and 15: 2. MOMENT ANALYSIS PROCEDURE The st
Page 16 and 17: error is introduced by the deconvol
Page 18 and 19: 3. ASSUMPTIONS AND LIMITATIONS Mome
Page 20 and 21: Figure 1. Example of a Raw Data she
Page 22 and 23: Volumetric Rate Used The greater of
Page 24 and 25: Figure 5. The ExponDecay plot after
Page 26 and 27: 5. POTENTIAL PROBLEMS AND OBSERVATI

Tracer Interpretation Using Temporal Moments on a Spreadsheet G

Create successful ePaper yourself

Delete template?

Save as template?