Rating of a helical gear pair - KISSsoft AG

More documents

Recommendations

Info

The KISSsoft input window then opens: Figure 3. KISSsoft Cylindrical gear calculation input window The following sections describe how to input parameters for the gear pair. 2.3 Gear Pair Geometry Input the normal module (1.5 mm), pressure angle (20°), helix angle (25°), center distance (48.9 mm), number of teeth (16/43), tooth widths (14/14.5 mm), profile shift coefficient (0.3215/...) and the quality (8/8) in the input window in the "Basic data" tab; "Geometry" group. You cannot input a value for the profile shift of gear 2 directly because this value is calculated from the center distance and profile shift of the first gear. However, you can click the Sizing button to size the value to match your requirements. You can set the quality to suit you, no matter which calculation method is in use. 04.03.2013 6 / 21
Figure 4. Module-specific settings. Quality does not depend on calculation method. Figure 5. Input window – "Basic data" tab, "Geometry" group Click the Convert button to the right of the input fields to enter additional data for each field, or to input other data for these particular values. If you need to input an angle, right-click in the input field to open another window in which you can enter the angle, minutes and seconds: Figure 6. Additional entries, normal module, angle 2.4 Defining the power data and calculation method Now, go to the input window in the "Rating" tab, group "Strength" and input the kinematics, the required service life (750 h) and the application factor (1.35). In this example, the torque is defined by inputting the power (3.5 kW) and speed (2500 1/min). However, in a different example, if you want to input the torque and calculate the power, simply set the "Selection" button to the right of the input field from torque to power. Under Details you can now input even more parameters about strength. It is also important that you set the reference gear correctly (first gear - gear 1) for the load. Input the calculation method in the drop-down list you see on the top left. In this case, you must also switch to ISO 6336 Method B. 04.03.2013 7 / 21
Page 1 and 2: KISSsoft 03/2013 - Tutorial 8 Verif
Page 3 and 4: 1 Task This tutorial explains how t
Page 5: 2 Solution 2.1 Starting the softwar
Page 9 and 10: Face load factor K Hß shows the no
Page 11 and 12: Figure 13. Input window "Tolerances
Page 13 and 14: 2.10 Report KISSsoft Release 03/201
Page 15 and 16: Grease temperature (°C) [TS] 80.00
Page 17 and 18: Without support effect Tooth trace
Page 19 and 20: Thermal contact factor (N/mm/s^.5/K
Page 21: 8. ADDITIONAL DATA Maximal possible

Rating of a helical gear pair - KISSsoft AG

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?