TRIDENT MODEL PD765 Instruction Manual

Trident Model PD765 Universal Input Meter
Instruction Manual
SETUP AND PROGRAMMING
• There is no need to recalibrate the meter
when first received from the factory.
• The meter is factory calibrated prior to
shipment, for all input types, in milliamps,
volts, and degrees respectively. The calibration
equipment is certified to NIST standards.
Overview
There are no jumpers involved in the setup process of the meter. The
RTD/TC selector switch, located between the SIGNAL and SERIAL
connectors, must be set accordingly for the meter to accept RTD or
thermocouple inputs, Figure 2.
Setup and programming is done through the front panel buttons.
After power and signal connections have been completed and verified,
apply power to the meter.
For
Quick User Interface Reference Guide
go to page 70
22