TECHNICAL CATALOGUE 2012 - AsEG Antriebstechnik GmbH

ORDER DaTa
additional information for SPecial dUtieS
S 2: ... min (short-time duty)
S 3: ... % - ... min (intermittent duty)
S 4: ... % - J M ... kgm 2 - J ext ... kgm 2 (intermittent duty with starting)
S 5: ... % - J M ... kgm 2 - J ext ... kgm 2 (intermittent duty with electric braking)
S 6: ... % - min (continuous-operation periodic duty with intermittent load)
S 7: .J M ... kgm 2 - J ext ... kgm 2 (continuous-operation periodic duty with electric braking)
S 8: .J M ... kgm 2 - J ext ... kgm 2 (continuous-operation periodic duty with speed changes)
S 9: ... kW (continuous duty with non-periodic load and speed variations).
For this duty type suitable full load values should be taken as the overload concept.
S10: p/∆t .... r .... TL (Duty with discrete constant loads).
additional information for SPecial oPeratinG conditionS
Starting conditions (no-load or loaded starting)
Shock loads
Load torque curve during run-up (characteristic)
Moment of inertia (J ext ) referred to the motor shaft: kgm 2
Description of the type of drive (direct coupling, flat or V-belt, straight or helical gears,
sprocket, crank, eccentric cam, etc.)
Radial force (or diameter of drive element): N
Direction of force and point of application (distance from shaft shoulder or width of drive
element): mm
Axial force and direction of application (pull/thrust): N
Ambient conditions (e.g. increased humidity, dust accumulation, corrosive gases or vapours,
increased or extremely low ambient temperature, outdoor installation, installation at altitudes
over 1000 m above sea level, external vibration, etc.)
32 General information - TEChNiCal CaTalOguE 1039/12