FLEXpower ONE Installation Manual - OutBack Power Systems
FLEXpower ONE Installation Manual - OutBack Power Systems
FLEXpower ONE Installation Manual - OutBack Power Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Conduit and Knockout Preparation<br />
Planning<br />
Knockouts (two 1”, one 2”) are provided on the ends of the AC and DC enclosures for routing cable<br />
into the enclosures. Conduit and bushings are recommended to prevent damage to conductors from<br />
sharp edges along knockout holes.<br />
1. Remove the 2” knockout on the DC end to accommodate the larger battery cables and Remote<br />
Temperature Sensor cable.<br />
2. Remove the 1” knockout(s) on the AC end to accommodate the AC cabling.<br />
3. Install conduit and bushings to protect the cable from damage from the sharp edges of the hole.<br />
4. Ensure no debris or metal shavings have fallen into the enclosures.<br />
AC End<br />
1”<br />
2”<br />
Top View<br />
Front Side<br />
Front Side<br />
Bottom View<br />
1” 2”<br />
DC End<br />
Figure 8<br />
Conduit and Knockout Preparation<br />
20 900-0095-01-00 Rev A
Change language