Project Manual/Specifications - Pavilion Construction

MARQUIS Newberg
05 50 00 – METAL FABRICATIONS
October 5, 2012
d. Failure of connections.
e. Other detrimental effects.
f. Base engineering calculation on surface temperatures of materials due to both solar heat
gain and nighttime-sky heat loss.
F. Environmental Characteristics:
1. Where choice exists, use pourable products, adhesives, and finishes that have no formaldehyde
content, are water-based rather than solvent-based, and are certified to not off-gas.
2. Use interior opaque topcoat paints that comply with VOC limits and chemical component
restrictions of Green Seal Standard GS-11.
3. At minimum, select materials that comply with Code of Federal Regulations Chapter 40, articles
59.400 – 59.413 governing V.O.C. emissions for architectural coatings.
4. Where choice exists, use composite products that contain highest possible percentage of recycled
material.
5. Where choice exists, obtain products from manufacturers closest to Project Site.
1.3 SUBMITTALS
A. Product Data: For the following:
1. Paint products.
2. Grout.
3. Provide documentation of VOC content of all adhesives, sealants, primers, and paints.
B. Shop Drawings:
1. Detail fabrication and erection of each metal fabrication indicated.
2. Include plans, elevations, sections, and details of metal fabrications and their connections.
3. Show anchorage and accessory items.
4. Provide templates for anchors and bolts specified for installation under other Sections.
5. For metal fabrications indicated in Performance Requirements article above to comply with design
loads, include structural analysis data signed and sealed by the professional engineer licensed in
Oregon responsible for their preparation.
C. Samples for Initial Selection:
1. Handrail Bracket:
a. Selection of units resembling brackets represented generically in Drawings, suitable to
substrates and installation conditions, and of metals indicated or, if not indicated, as
directed by Architect.
2. Powder-coating color chart, including colors within range indicated by Architect.
D. Samples for Verification:
1. Handrail Bracket: Full-size unit with finish selected from Samples for Initial Selection..
2. Approved sample in good condition may be installed in final work.
E. Welding Certificates:
1. Copies of certificates for welding procedures and personnel.
F. Qualification Data:
1. For firms and persons specified in "Quality Assurance" Article to demonstrate their capabilities and
experience.
2. Include lists of completed projects with project names and addresses, names and addresses of
architects and owners, and other information specified.
1.4 QUALITY ASSURANCE
05 50 00 – METAL FABRICATIONS
page 2