TERRASEM 3000 TERRASEM 4000 Operating instructions
TERRASEM 3000 TERRASEM 4000 Operating instructions
TERRASEM 3000 TERRASEM 4000 Operating instructions
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
DISCRIPTION<br />
GB<br />
Connect hydraulic hoses<br />
ST<br />
Observe colours of protecting caps!<br />
Track marker<br />
- single action control device (red),<br />
- observe correct connection:<br />
“Raise” / swing in (red),<br />
“Lower” / swing out (yellow),<br />
6<br />
Hydraulic shear pressure adjustment<br />
- double action control device (red / blue).<br />
- pressure 30 - 35 bar (indicator on pressure<br />
gauge)<br />
Adjust pressure:<br />
1. Connect hydraulic hoses to tractor<br />
2. Open stop valve (Pos. E).<br />
3. Set the hydraulic valve (ST) to pressure.<br />
Pressure will now built up to 35 bar.<br />
- any alteration to this pressure is possible<br />
through the adjusting screw (SK).<br />
4. Close stop valve (Pos. A).<br />
5. Set the hydraulic valve (ST) at 0.<br />
Hydraulic fan drive (variation)<br />
Observe special notes for hycraulic fan drive!<br />
See chapter "Adjusting the hydraulic fan drive"<br />
Electricity supply for electronic tramline switching:<br />
12V for 3-pole constant current socket (DIN 9680). (If this is<br />
not available, a battery connection cable with socket or an<br />
adaptor for the 7-pole trailer socket (requires parking light to<br />
be switched on) can be supplied by PÖTTINGER as additional<br />
equipment).<br />
Place the cable in the hooks on the seed drill side to take<br />
strain off the plug connection – see (6/1).<br />
0200-GB BESCHREIBUNG_8551<br />
- 10 -
Change language