TERRASEM 3000 TERRASEM 4000 Operating instructions

DISCRIPTION
GB
2
4
V belt drive
1
In order to position and remove the V belts loosen the tensioner
as far as it will go - with a spindle (7/1: before loosening the
safety screws 7/2, then increase tension again).
3
7
Belt tension see Fig. 8:
Test force ca. 25 N, deflection ca. 15 mm.
Release tension after around 20 minutes on the first use.
Check belt tension daily
Take special care of the following on the drive:
The drive mechanism must be exactly aligned; bring fans into
line if necessary – screws (7/3 and 7/4).
8
In the case of a fault with the belt, change both V belts – XPZ
belts; only use belts of the same length (L=L).
2
1
Always fasten the safety device:
On the fan (4/3) and the belt guard (9/1) – assemble the
attached protective wedge (9/2) close to the belt pulley.
Setting Seed Rates
9
One coarse Setting Seed Rates
One coarse (40) and two fine proportioning wheels (40a,40b)
with three settings and RPM adjustor vary the sowing rate.
(Additional equipment for peas available on request).
Power is taken from a drive wheel that runs on the working
area
– set the ground pressure of the drive wheel on the turnbuckle
(11/1).
1
10
Possible settings (given in seed chart):
1. Proportioning wheel setting
2. Gear setting – along a scale
3. Bottom flap
4. Butterfly flap
5. Calibration flap (only change when calibrating)
6. Agitator shaft (remove agitator for rape)() and two fine
proportioning wheels (10/1 + 2) with three settings and RPM
adjustor vary the sowing rate. (Additional equipment for
peas available on request).
0200-GB BESCHREIBUNG_8551
- 11 -