TERRASEM 3000 TERRASEM 4000 Operating instructions
TERRASEM 3000 TERRASEM 4000 Operating instructions
TERRASEM 3000 TERRASEM 4000 Operating instructions
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
AUSSAATMENGE EINSTELLEN<br />
(ABDREHEN)<br />
D<br />
Dosing unit description<br />
General<br />
The dosing shafts monitor signals the driver if the dosing shaft stops<br />
during operation (disruption to the drive).<br />
Ensure that both sensor baskets are synchronized when running.<br />
- when the left sensor shows a break, then the right must also.<br />
- gap between sensor and sending container is 1-3 mm<br />
Standard equipment<br />
• a coarse dosing wheel (pos. 40)<br />
• two fine dosing wheels (pos. 40a, 40b)<br />
Optional equipment<br />
• a coarse dosing wheel (pos. 48b)<br />
- for coarse seeds like peas and beans<br />
- for sowing quantities up to 250 kg/ha<br />
• a coarse dosing wheel (pos. 48c)<br />
- for hybrid seeds like linseed, grass, sunflowers<br />
- for lower sowing quantities from 30 - 40 kg/ha<br />
Adjusting seed quantity per hectare<br />
Turning off<br />
So-called ”Turning off” establishes what quantity (kg) of seed per hectare<br />
will be sown by adjusting the dosing device accordingly. Doing this<br />
enables the dosing device on the seed drill to be adjusted exactly to the<br />
desired seed quantity.<br />
A more exact description of this is in the operating <strong>instructions</strong> for the<br />
”Artemis” seed drill control found in the supplement of this operating<br />
manual.<br />
• However before proceeding with ”Turning off”, the<br />
notes on the following pages should be<br />
observed.<br />
As seeds vary greatly through specific weight, kernel size, kernel form and<br />
seed dressing gear, the sowing table values are only approximations.<br />
Therefore a trial turning off should be carried out.<br />
40b<br />
40<br />
40a<br />
Where variations to the sowing quantity occur, turn off again using an<br />
altered drive position.<br />
- use the accompanying seed disc as an aid.<br />
Attention! For safety reasons, remove the crank handle<br />
after turning off.<br />
Note: The electronic tramline switch Multitronic II has a<br />
"Turn off aid" function with whose support the number of<br />
necessary turn of the turn off crank needed is calculated<br />
and counted from the seed monitor for the selected turn<br />
off area.<br />
- see Multitronic II operating <strong>instructions</strong>.<br />
48b<br />
48c<br />
168-01-48<br />
0001-D ABDREHEN_8551<br />
- 12 -
Change language