IDA 4 XM V 2.X - Radio Matériel

LXXX OPENED
LXXX IMPED.
LXXX LEAKAGE
The corresponding line is open.
Check the line wiring.
The measured impedance is out of the defined tolerance.
Look at part 1.3.3 to configure the impedance tolerance.
An earth leakage fault is detected on the corresponding
line.
Check the line wiring.
Call station faults
Fault message
PXXX PREAMP.
PXXX INP.SP
PXXX MICRO
PXXX OUT MIC
PXXX SCREEN
PXXX TACTILE
PXXX INP.IDA
PXXX ABSENT
PXXX COMMUNICATION
Description
Fault on call station microphone preamplifier.
Fault on call station speaker input.
Fault on call station microphone.
Fault on call station microphone output.
Fault on call station display.
Fault on call station touch screen.
Fault on IDA4 call station microphone input.
The corresponding call station is not connected to IDA4.
If there is no call station, put the call station priority on Low.
The fault message will disappear.
Communication fault between call station and IDA4.
Check the wiring between call station and IDA4.
Message faults
Fault message
MXXX ABSENT
Description
There’s no message stored in IDA4 memory.
Look at part 1.3.4 MESSAGES > GENERAL to store a
message in IDA4 memory.
If no message has to be stored in IDA4 memory, put the
message priority on Low. The fault message will disappear.
External faults
Fault message
DXXX DEFECT
Description
The fault input is activated.
Look at part 1.3.9 FAULT INPUTS to configure the fault
input (fault consequence, activation mode, fault mode).
Telesonorisation faults
Fault message
TXXX ABSENT
TXXX DEF.DEF
TXXX DEF.IMM
Description
Communication fault with remote IDA4 system.
Immediate fault on remote IDA4 system.
Deferred fault on remote IDA4 system.
User_manual_IDA4XM_V2.x.doc
Page 45 of 51