Dominion SX 3.1.6 User Guide - English - Raritan

Chapter 4: Initial Software Configuration
After you click OK, the system displays one of the following pages:
• A confirmation page, which contains the settings you chose and a
confirmation message at the top of the page.
• An error page, which contains the original Date / Time page and the
error message.
Network Configuration
1. Choose Setup > Network. The Network Configuration page opens.
Note: If you have a dual LAN model, there is an Enable Ethernet
Failover checkbox that is selected by default, but can be deselected.
The page below represents a single LAN model and does not show
this checkbox.
Note: Your network administrator usually assigns the values for the
following parameters:
2. Type the data in the following fields:
• IP Auto Configuration: In the drop-down menu, select either None
or DHCP to be your network protocol. Default is None.
• IP Address: Network address for this unit.
• Subnet Mask: Subnet mask for the network where this unit will
reside.
• Gateway IP Gateway: Default gateway for this unit.
3. Select the Mode from the Mode drop-down menu. Default is Auto.
19