TK-880/H (UHF) mobile service manual - The Repeater Builder's ...
TK-880/H (UHF) mobile service manual - The Repeater Builder's ...
TK-880/H (UHF) mobile service manual - The Repeater Builder's ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
INSTALLATION<br />
<strong>TK</strong>-<strong>880</strong>/H<br />
6-3. Installing the KCT-31 in the transceiver<br />
Note :<br />
When the COM1 is used, A connector is unused.<br />
When the COM2 is used, C connector is unused.<br />
2. Make sure the unit’s power is turned off.<br />
3. Remove the upper case of the transceiver and lift the DC<br />
cable bushing ( 1 ) from the chassis.<br />
4. Remove the pad as shown in Figure 8 ( 2 ).<br />
1. Bind the unused connecor to the cable with a retaining<br />
band as shown.<br />
When the COM1 is used.<br />
When the COM2 is used.<br />
C<br />
A<br />
Yellow<br />
Yellow<br />
B<br />
Green<br />
B<br />
Green<br />
1<br />
Red<br />
Red<br />
2<br />
Black<br />
Black<br />
A<br />
C<br />
Fig. 8<br />
A B C<br />
COM1 No Yes Yes<br />
COM2 Yes Yes No<br />
Fig. 7<br />
5. Insert the KCT-31 cable ( 3 ) into the chassis ( 4 ).<br />
<strong>The</strong> write retaining band ( 5 ) must be inside the chassis.<br />
6. Replace the DC cable bushing ( 6 ).<br />
7. Connect the KCT-31 to the TX-RX unit (A/2) as shown in<br />
Figure 9 ( 7 ).<br />
8. Replace the upper case.<br />
A<br />
A<br />
C<br />
CN4<br />
CN1<br />
CN4<br />
CN1<br />
B<br />
B<br />
CN3 CN2<br />
B<br />
CN3 CN2<br />
5<br />
4<br />
CN6<br />
CN6<br />
6<br />
3<br />
7<br />
When the COM1 is used.<br />
When the COM2 is used.<br />
Fig. 9<br />
Note :<br />
· <strong>The</strong> modification must be applied to the <strong>TK</strong>-<strong>880</strong>/<strong>880</strong>H<br />
transceivers with a serial number of 30200000 or smaller<br />
when using a COM2 port. Replace the 47kΩ (R675) chip<br />
resistor on the TX-RX unit (B/2) with a 4.7kΩ resistor.<br />
· Enable the serial port function on the terminal.<br />
· Refer to the <strong>service</strong> <strong>manual</strong> of each radio or the help file<br />
that came with the FPU (Field Programming Unit) for details.<br />
Original<br />
New<br />
47kΩ (RK73GB1J473J) → 4.7kΩ (RK73GB1J472J)<br />
25