TK-880/H (UHF) mobile service manual - The Repeater Builder's ...
TK-880/H (UHF) mobile service manual - The Repeater Builder's ...
TK-880/H (UHF) mobile service manual - The Repeater Builder's ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
INSTALLATION<br />
<strong>TK</strong>-<strong>880</strong>/H<br />
6. Rotate the control panel 180 degrees and mount it on the<br />
transceiver. Refit the two halves of the case to complete<br />
installation. (Fig. 13)<br />
9-2. KES-4 : Option<br />
<strong>The</strong> KES-4 is an external speaker used with the accessory<br />
connection cable.<br />
• Connection procedure<br />
1. Install the KCT-19 in the transceiver. (See the KCT-19<br />
section.)<br />
2. Insert the crimp terminal into the square plug supplied<br />
with the KCT-19.<br />
3. Connect CN5 of the transceiver to connector C of the<br />
KCT-19 instead of to the internal speaker connector.<br />
KES-4<br />
Fig. 13<br />
9. External Speaker<br />
9-1. KES-3 : Option<br />
<strong>The</strong> KES-3 is an external speaker for the 3.5-mm-diameter<br />
speaker jack.<br />
• Connection procedure<br />
1. Connect the KES-3 to the 3.5-mm-diameter speaker jack<br />
on the rear of the transceiver.<br />
13<br />
15<br />
12<br />
1<br />
3<br />
6<br />
Crimp terminal<br />
(E23-0613-05)<br />
Black lead<br />
Black/White lead<br />
Fig. 15<br />
Note : When installing KES-4, you must use an optional<br />
cable, KCT-19. Do not connect the KES-4 to 3.5mm<br />
speaker jack. <strong>The</strong> performance may be degrade.<br />
KES-3<br />
Fig. 14<br />
27