BREAKTHROUGH IN X-RAY DIFFRACTION GENERATORS! - Rigaku

Specifications
X-RAY GENERATOR
• Maximum Load: 18kW
• Tube Voltage: 20-60kV in 1kV steps
• Tube Current: 10-300mA in 1mA steps [10-450mA (40kV) in 1mA steps (Optional)]
• Stability of High Voltage: +/- 0.01% for a +/-10% variation in the line voltage and +/- 5°C
change in ambient temperature
• Ripple: 1% rms or less (at 60kV, 300mA)
ROTATING ANODE ASSEMBLY
• Material: Select one from Cu (standard), Cr, Fe, Co, Ni, Mo, Ag, W, and Au
• Target diameter: 10cm (common to horizontal and vertical types)
• Rotation speed: 6000rpm
• Vacuum sealing for rotary shaft: Low torque type magnetic fluid sealing
• Bearing: Ceramic bearing
• Water sealing: Mechanical seal
X-RAY SOURCE SIZE
• Focal spot size on the target: 0.5 x 10mm 2 as standard (Option: 0.3 x 3mm 2 , 0.2 x2mm 2 ,
0.1 x 1mm 2 )
• Effective size at 6° take-off angle: 0.05 x 10mm 2 (line focus), 0.5 x 1mm 2 (point focus)
OPERATION PANEL
• Manual control: Controller from the operation panel
• External control: RS-232C interface is built-in to allow control from the host computer
SAFETY DESIGN
• An LED is used in the warning lamp to prolong life
• Shutter functions are monitored. If failure occurs, the entire system will shut down.
HEAT EXCHANGER (Optional)
• Water cooled type or air cooled type heat exchanger are available
RADIATION ENCLOSURE (Optional)
• Radiation Enclosures: 1200 x 1000 and 1800 x 1000mm (each with fail safe release function)
Rigaku/MSC, Inc., 9009 New Trails Dr., The Woodlands, TX 77381