Reference Manual - Segway

More documents

Recommendations

Info

Removing the Handlebar Tool Required: 3mm hex wrench. To remove the Handlebar from the LeanSteer Frame: 1. Make sure the <strong>Segway</strong> PT is unplugged and powered off. 2. Using the 3mm hex wrench, remove the 3 fasteners that secure the Handlebar Clamp to the LeanSteer Frame. 3. When you remove these fasteners and the Handlebar Clamp, the Handlebar is released from the LeanSteer Frame (see Figure 33). Figure 33. Remove Handlebar from the LeanSteer Frame 98
Attaching the Handlebar English Tool Required: Torque wrench with 3mm bit. To attach the Handlebar to the LeanSteer Frame: 1. Make sure the <strong>Segway</strong> PT is unplugged and powered off. 2. Align the Handlebar in place against the LeanSteer Frame using the alignment guides. See Figure 34. 3. Position the Handlebar Clamp against the Handlebar. 4. Insert the 3 fasteners through the Handlebar Clamp into the LeanSteer Frame. 5. Using the 3mm hex wrench, alternate between the 3 fasteners, evenly tightening in small increments until the full torque setting of 6.0 N-m (4.4 ft-lbf) is achieved. 6. Check to ensure that the gap between the Handlebar Clamp and the LeanSteer Frame is even, and the same between the top and bottom. Figure 34. Secure Handlebar to LeanSteer Frame 99
Page 1:
French
Page 4 and 5:
Copyright, Trademark and Contact In
Page 6 and 7:
Understanding the Rider Detect Sens
Page 8 and 9:
A Contact and Legal Information Rep
Page 10 and 11:
The Risk of Injury The Segway PT is
Page 12 and 13:
Conventions The following conventio
Page 14 and 15:
Segway PT Serial Number To record t
Page 16 and 17:
Segway PT Model Descriptions Table
Page 18 and 19:
Table 2. Segway Specifications Mode
Page 20 and 21:
Operating Limits It is important th
Page 22 and 23:
Structural Weight Limits Exceeding
Page 25 and 26:
Chapter 2: Getting to Know Your Seg
Page 27 and 28:
English Figure 4. How Segway PT Wor
Page 29 and 30:
English WARNING! All Segway PT part
Page 31 and 32:
InfoKey Controller You use the Info
Page 33 and 34:
Table 3 describes each of the butto
Page 35 and 36:
Table 3. InfoKey Controller Buttons
Page 37 and 38:
Beginner Button Functions The follo
Page 39 and 40:
Setting and Resetting Information T
Page 41 and 42:
5. Set Day Select the day by tappin
Page 43 and 44:
Button Combination Functions The fo
Page 45 and 46:
5. The third person may then press
Page 47 and 48:
Mats English Your Segway PT comes w
Page 49 and 50:
Balance Indicator Lights Five Balan
Page 51 and 52:
Green Balance Indicator lights indi
Page 53 and 54:
Understanding the Rider Detect Sens
Page 55 and 56:
Controller Boards Figure 12 shows t
Page 57 and 58:
Balance Sensor Assembly Figure 14 s
Page 59 and 60: Chapter 3: Understanding the Safety
Page 61 and 62: English WARNING! Riding against the
Page 63 and 64: Stick Shake Warning One of the ways
Page 65 and 66: English Table 6. Stick Shake Warnin
Page 67 and 68: Safety Shutdown If the Segway PT de
Page 69 and 70: English WARNING! Never restart and
Page 71 and 72: Empty Battery Condition English The
Page 73 and 74: Chapter 4: Using the Batteries This
Page 75 and 76: Specifications for the Batteries Ta
Page 77 and 78: To charge the Batteries: 1. Put you
Page 79 and 80: 6. Verify that the two Charge Indic
Page 81 and 82: Battery Charge Indicator Lights Eng
Page 83 and 84: Reading the Battery Charge Level Di
Page 85 and 86: English NOTE: Depleting your Segway
Page 87 and 88: Table 11 shows the InfoKey Controll
Page 89 and 90: Replacing Batteries Your Segway PT
Page 91 and 92: Shipping Li-ion Batteries English T
Page 93 and 94: Chapter 5: Operating and Maintainin
Page 95 and 96: English WARNING! Watch Your Fingers
Page 97 and 98: English WARNING! The tire pressure
Page 99 and 100: Avoid Submerging Your Segway PT Eng
Page 101 and 102: Chapter 6: Servicing Your Segway PT
Page 103 and 104: If you have a question on parts or
Page 105 and 106: Removing the LeanSteer Frame Englis
Page 107 and 108: 4. Slide the LeanSteer Frame away f
Page 109: 5. Prior to tightening the fastener
Page 113 and 114: To remove the Batteries: 1. Make su
Page 115 and 116: 1. Make sure the Segway PT is unplu
Page 117 and 118: 3. Rotate the Powerbase until the v
Page 119 and 120: Installing the Tire/Wheel Assembly
Page 121 and 122: Removing/Installing the Mats Englis
Page 123 and 124: 4. If you are replacing the battery
Page 125 and 126: Installing/Removing the InfoKey Con
Page 127 and 128: Installing/Removing the Dock Adapte
Page 129 and 130: To Undock the InfoKey Controller: 1
Page 131 and 132: Chapter 7: Troubleshooting the Segw
Page 133 and 134: If you are unable to solve the prob
Page 135 and 136: Segway PT Will Not Enter Balance Mo
Page 137 and 138: Tire/Wheel Assembly is Loose and Wo
Page 139 and 140: Tire is Flat or Will Not Hold Air E
Page 141 and 142: 5. If reseating the InfoKey Control
Page 143 and 144: English Table 14. Icons for Startup
Page 145 and 146: Reduced Performance Levels English
Page 147 and 148: Pitch or Roll Angle Exceeded Englis
Page 149 and 150: Appendix A: Contact and Legal Infor
Page 151 and 152: • Reorient or relocate the receiv
Page 153 and 154: Patent Information The Segway PT is
Page 155 and 156: Index A Accessories 91 Attaching th
Page 157 and 158: S Safety alerts 47 Safety Shutdown
Page 160:
French
show all

Reference Manual - Segway

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?