VSA-E03 - Service.pioneer-eur.com - Pioneer

Sound Modes
Adjusting bass and treble (tone control)
Use BASS (–/+) or TREBLE (–/+) to adjust the low and high frequencies.
TREBLE –/+
Press BASS (–/+) to adjust the low frequencies.
SIGNAL
SELECT
ANALOG
SP
A
dB
Press TREBLE (–/+) to adjust the high frequencies.
BASS –/+
SIGNAL
SELECT
ANALOG
SP A
dB
memo
• The tone control can be adjusted in a range of ±6.
• Pressing + and – simultaneously restores the setting to 0.
• In cases described below, the tone control cannot be adjusted.
1 Dolby Surround mode is ON.
2 DSP mode is ON.
3 DVD 5.1ch input is selected.
4 Dolby Digital signals are being input.
Adjusting the brightness of the display
Use FL DIMMER to adjust the brightness of the fluorescent display.
AMP
TV
MUTING
VOL
FQ
+
ENTER
–
FQ
TV FUNC
VOL
Press FL DIMMER.
Four levels of brightness ranging from very dim to very bright can be
selected. Each press changes the brightness of the display. When rotating
through the options, the default brightness can also be selected.
CHANNEL
MULTI CONTROL
DVD/LD TV/SAT CD
VCR 1
TV CONTROL
TUNER
VCR 2
AMP
MD/TAPE
DSP MODE
MIDNIGHT
1 2 3 4
CH.SELECT TEST TONE ATT SIG.SELECT
5 6 7 8
CH.LEVEL EFFECT
9 0 +10 MEMU
FUNCTION DIRECT
MODE CHECK
CLASS
TV/VCR
FL DIMMER
COMMANDER
SET UP
FL DIMMER
memo
In standby, pressing STANDBY/ON while holding down (Dolby)
Surround button (both on the front panel) returns the display to the default
brightness.
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
32
En