FlexFrame Specification Guide - Steelcase

FlexFrame
Electrical, continued
.
A base power tray
without a receptacle
kit can be used to route
modular harnesses and
cords through a section.
Cords and cables can
pass through the bottom of
a base power tray.
Base power tray should
not be used in 22 5 /8"H workwalls
because the wire management
cut-out in the inner
vertical frame piece cannot
accommodate modular
power.
Tip: Use workwall wire manager
for 22 5 /8"H workwalls.
Receptacle kits may not
be placed behind a drawer.
.
Technology skins can
not be used in front of
receptacle kits.
Skins for bins are not
aligned with the front edge
of the workwall frame. The
skins set back an additional
1" to allow for more room in
the bins. Base power tray
will not fit behind these
skins.
Cable management
skins for bins are aligned
at the front edge of the workwall
frame. This allows for
wiring and base power trays
behind the skin. Consider
this when determining the
storage capacities of the
bins.
.
1 3 /4"
Inner vertical frame
pieces used with
47 15 ⁄16", 64 7 ⁄16", or
80 15 ⁄16"H workwall
frames come standard with
a cut-out for wire management
near the bottom of the
vertical frame piece.
5 /8"
1 5 /16"
1"
Inner vertical frame
pieces used with
22 5 /8"H workwall
frames have a smaller
cut-out designed to manage
LED light cords and not
power cords.
.
Surface Materials
Receptacle kits
• 6000 Black
Base Power Tray
• 7237 Slate
Workwall Wire
Manager
• 7237 Slate
.
.
60 FlexFrame Specification Guide
November 2010