INVITATION FOR BID - University of Central Missouri

21
9.6 Each Contractor shall coordinate all work so there shall be no prolonged interruption of
existing equipment operation. Any existing plumbing, heating, ventilating, air conditioning
or electrical disconnections necessary which affect portions of this construction or building
or any other building must be scheduled with the Contract Administrator to minimize or
avoid any disruption of facility operations. In no case, unless previously approved in writing
by the Construction Inspector, shall utilities be left disconnected at the end of a work day or
over a weekend. Any interruption of utilities either intentionally or accidentally shall not
relieve the Contractor responsible for the interruption from repairing and restoring the utility
to normal service. Repairs and restoration shall be made before the workmen responsible
for the repair and restoration leave the job.
9.7 Each Contractor shall be responsible for repair of his damage to property on or off the
project occurring during construction of project, and all such repairs shall be made to the
satisfaction of the property owner.
9.8 Contractors shall not overload, or permit others to overload, any part of any structure during
the performance of this contract.
9.9 Each Contractor shall be responsible for shoring required to protect his work or adjacent
property and improvements of Owner and shall be responsible for shoring or for giving any
required notice to adjacent property owners and shall pay for any damage caused by failure
to shore or by improper shoring or by failure to give proper notice. Shoring shall be
removed only after completion of permanent supports.
9.10 During the performance of work the Contractor shall be responsible for providing and
maintaining warning signs, lights, signal devices, barricades, guard rails, fences and other
devices appropriately located on site which will give proper and understandable warning to
all persons of danger of entry onto land, structure or equipment. Such warning and
protective devices shall be removed only when approved by the Contract Administrator or
Designer.
9.11 The Contractor shall be responsible for protection, including weather protection, and proper
maintenance of all equipment and materials installed or to be installed by him.
9.12 The Contractor shall be responsible for care of his finished work and shall protect same from
damage or defacement until final acceptance by the Owner. If the work is damaged by any
cause, the Contractor shall immediately begin to make repairs in accordance with the
drawings and specifications. Contractor shall be liable for all damage or loss unless
attributable to the acts or omissions of the Owner or Designer. Any claim for
reimbursement shall be submitted in accordance with Article 23.
9.13 The Contractor shall be responsible for initiating, maintaining and supervising all safety
precautions and programs in connection with the performance of the Contract.
9.13.1 In the event the Contractor encounters on the site material reasonably believed to
be asbestos or polychlorinated biphenyl (PCB) which has not been rendered
harmless, the Contractor shall immediately stop work in the area affected and
report the condition to the Owner. The work in the affected area shall not
thereafter be resumed except by written agreement of the Owner and Contractor if
in fact the material is asbestos or polychlorinated biphenyl (PCB) and has not been