INVITATION FOR BID - University of Central Missouri

shall be located as directed and shall include sample panels constructed at site size as
required.
29
16.11 All tests required by the specifications shall be paid for by the Contractor and performed by
testing laboratories approved by the Owner.
17. MATERIALS AND WORKMANSHIP
17.1 Unless otherwise specified, all materials shall be new and both workmanship and materials
shall be of the best quality. If required by the Owner, satisfactory evidence shall be
furnished as to the kind and quality of the materials and workmanship.
17.2 All materials and workmanship used in the work shall be subject to the inspection of the
Designer and Contract Administrator, and any work which is deemed defective shall be
removed, rebuilt or made good. The cost of such correction shall be borne by the
Contractor. All condemned materials shall be immediately removed from the site of the
work.
17.3 Failure or neglect on the part of the Owner to condemn or reject bad or inferior materials or
workmanship shall not be construed to imply an acceptance of any work. The work herein
specified to be done is not to be considered as finally accepted until it is so stated in writing
by the Owner.
17.4 Unless otherwise provided and stipulated within these specifications, the Contractor shall
furnish, construct, and/or install and pay for materials, devices, mechanisms, equipment, all
necessary personnel, utilities including, but not limited to water, heat, light and electric
power, transportation services, applicable taxes of every nature, and all other facilities
necessary for the proper execution and completion of the work.
17.5 All temporary shoring, bracing, etc., required for the removal of existing work and/or for the
installation of new work shall be included in this contract. This must be done to the entire
satisfaction of the Owner but the Contractor must assume full responsibility for the work.
The Contractor shall make good, at no cost to the Owner, any damage caused by improper
support or failure of shoring in any respect.
17.6 Contractor shall, at all times, enforce strict discipline and good order among his employees,
and shall not employ on the work any unfit person or anyone not skilled in the work
assigned to him.
17.7 Contractor shall carefully examine the plans and drawings and shall be responsible for the
proper fitting of his material, equipment and apparatus into the building.
17.8 Contractor shall base his bid only on materials, method of construction and equipment as
indicated.
17.9 Contractor shall promptly remove at his own expense all rejected materials from site of
work.
17.10 When a material has been approved, no change in brand or make will be permitted unless: