Permit to Work Major Hazard Standard - MIRMgate

More documents

Recommendations

Info

WMC EHS Management System Major Hazard Standard Permit to Work Radioactive Substances) Regulations 1992 and various conditions imposed by the Radiological Council SP 25 High Voltage and Access Procedures EHS MS Management Standard #5 – Management of Change WMC-EHS-MHS-007 DocsOpen Ref : 155520 Issued: 23/12/03 Page 14 of 59
WMC EHS Management System Major Hazard Standard Permit to Work 10 TABLE 1 Guide for When a Work Permit is Required Note: Each site shall decide and document which types of high-risk work require a Work Permit. This analysis shall be risk based and consider the type of activity as well as different geographical areas of the site in which the activity takes place. • Tasks requiring level 2 isolation • Work in Confined Spaces • Work with High Voltage equipment WORK PERMIT REQUIRED • Hot work in Classified Areas (Class 1, Zone 0 and 1) • When isolating safety control systems or devices • All work on ionising radiation sources and working within 1 metre of radiation source (dosage based assessment. For example, work in areas or with products that emit natural radiation are excluded) • Excavation greater than 300mm in vicinity of buried services The following general criteria is provided to assist sites in deciding what other work requires a Work Permit: • Work at heights • Work in designated areas • Work with special hazards • Whenever swinging blanks or blinds in hazardous systems • Work of high complexity • Work involving inexperienced personnel. WMC-EHS-MHS-007 DocsOpen Ref : 155520 Issued: 23/12/03 Page 15 of 59
Page 1 and 2: WMC Environment, Health & Safety Ma
Page 3 and 4: EHS MS WMC EHS Management System Ma
Page 5 and 6: WMC EHS Management System Major Haz
Page 13: WMC EHS Management System Major Haz
Page 59: WMC EHS Management System Major Haz

Permit to Work Major Hazard Standard - MIRMgate

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?