Wadkin JET Tenoner Manual and Parts List

More documents

Recommendations

Info

20 For vertical and swivel adjuGtment of clamps, loosen locking handle 'E' FIG.20 and adjust to required position. Relock locking handle 'E' . For horizontal adjustment of clamps, loosen screw 'F' and adjust to required position. Relock screw 'F'. NOTE: DIAGRAMS FOR PNEUMATIC SHOULDER STOPS AND PNEUMATIC CLAMPS ARE ON PAGES 22. DRIVE BELT REPLACEMENT OR TENSIONING Traverse of cutter head is through drive motor and belt to lead screw. To adjust belt or Change, proceed as followsj 1) Isolate machine electrically. 2) Remove drive belt cover at rear of machine. 3) Release tension on pulleys by 4 - MiD hexagon head bolts 'G' FIG.21. 4) Position new belt over pulleys and tension belt by sliding plate 'H'. Correct tension will have been achieved when belt can be pulled iDmm in centre span. --.. ------------ www.wadkin.com info@wadkin.com
21 www.wadkin.com info@wadkin.com Fig21
Page 1 and 2: LEICESTER TENONING & END JOINTING S
Page 3 and 4: PREFACE IMPORTANT IT IS OUR POLICY
Page 5 and 6: 3 Safety CAREFULLY READ INSTRUCTION
Page 7 and 8: 150 OIA. IlL- OUTLE-=f1 1 VOLUME OF
Page 9 and 10: TRAVERSE MOTOR U1 I vll W1L ~ 'dL V
Page 11 and 12: 9 SLINGING Always use a sling withi
Page 13 and 14: 11 www.wadkin.com info@wadkin.com F
Page 15 and 16: 13 www.wadkin.com info@wadkin.com F
Page 17 and 18: 15 • • • • \\T j ~ www.wadk
Page 19 and 20: 17 www.wadkin.com info@wadkin.com f
Page 21: a-e I ,~ , www.wadkin.com info@wadk
Page 25: ~ Application A P PRO V E 0 L U B R

Wadkin JET Tenoner Manual and Parts List

Create successful ePaper yourself

Delete template?

Save as template?