C 3201 - Dimotec

C 3201
SUBCAB ® 4G25 mm 2
4G25+2x1,5 mm 2
4G35 mm 2
4G35+2x1,5 mm 2
Y/D start
SUBCAB ® 2x4G10+2x1,5 mm 2
7G6+2x1,5 mm 2
Monitoring equipment
Thermal contacts opening temperature 125 °C
Material
Impeller
Cast iron
Pump housing
Cast iron
Stator housing
Cast iron
Shaft
Carbon steel
O-rings
Nitrile rubber
Mechanical face seals
Alternative Inner seal Outer seal
1 Corrosion resistant Corrosion resistant
C 3201
cemented carbide/ cemented carbide/
Corrosion resistant
cemented carbide
Corrosion resistant
cemented carbide
Product
Surface Treatment
All cast parts are primed with a water-borne primer. The finishing coat
Submersible pump for pumping clean water, surface water and waste
is a high-solid two pack paint.
water containing solids or long-fibred material.
Denomination
Product code 3201.180
Weight
See dimensional drawing.
Process data
Installation P, S, T, Z
Impeller characteristics LT, MT, HT, SH
Option
3201.091 Ex. proof design
3201.280 Stainless steel design
Liquid temperature max +40 °C
3201.980 Industrial design
Depth of immersion
max 20 m
3201.290 Stainless steel/Ex proof design
The pH of the pumped liquid pH 5,5-14
Warm liquid version on request
Liquid density max. 1100 kg/m 3 Leakage sensor in stator housing
FLS
Impeller throughlet
See Motor rating table
Leakage sensor in oil housing
CLS
Motor data
Frequency
50 Hz
Surface treatment
Epoxy treatment
Other cables
Zinc anodes
Insulation class H (+180 °C)
Accessories
Voltage variation
- continuously running max ± 5%
Discharge connections, adapters, hose connections and other
mechanical accessories.
- intermittent running max ± 10%
Electrical accessories such as pump controller, control panels, starters,
Voltage imbalance between phases max 2%
monitoring relays, cables.
No. of starts/hour max 30
See separate booklet or www.flygt.com, for further information.
Cable
Direct-on-line start
SUBCAB ® 4G10+2x1,5 mm 2
3