Hitech Pro User Manual English - Tuncmatik
Hitech Pro User Manual English - Tuncmatik
Hitech Pro User Manual English - Tuncmatik
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
• Screen 4.12: This is an alarm for parallel systems. It appears when some UPS of the parallel<br />
system block because the maintenance bypass switch of any unit is switched ON.<br />
• Screen 4.13: This alarm indicates that the CAN BUS #1 fails. This communication channel is used<br />
for remote control.<br />
• Screen 4.14: This alarm indicates that the CAN BUS #2 fails. This channel is used for data<br />
communication between UPS, in a parallel system.<br />
• Screen 4.15: This alarm appears at the estimated end of live of the battery bank. The revision and<br />
replacement of some batteries will be necessary to be done by calling the S.T.S. (Service and<br />
Technical Support) department..<br />
Representation in display<br />
LCD<br />
RECTIFIER<br />
OVERLOAD<br />
INVERTER<br />
OVERLOAD<br />
MAINS FAILURE<br />
LOW BATTERY LEVEL<br />
INVERTER VOLTAGE<br />
OUT OF MARGINS<br />
DC VOLT. DETECTED<br />
AT THE OUTPUT<br />
MAINTENANCE BYP.<br />
INVERTER NOT AVAIL.<br />
MAINS FAILURE<br />
BATTERY DISCHARGING<br />
HIGH TEMPERATURE<br />
REDUCE OUTPUT LOAD<br />
BATT. SWITCH OPEN<br />
SWITCH IT ON<br />
BYPASS FAILURE<br />
NOT SYNCHRONIZED INV<br />
UPS ON BYPASS<br />
INITIALIZE THE UPS<br />
SOME UNIT BLOCKED<br />
DUE TO MAINT. BYPASS<br />
Representation in display<br />
LCD<br />
CAN BUS 1<br />
COMMUNICATION FAIL.<br />
CAN BUS 2<br />
COMMUNICATION FAIL.<br />
Alarms<br />
Ref.<br />
RECTIFIER 4.1<br />
4.2<br />
4.3<br />
INVERTER<br />
4.4<br />
4.5<br />
4.6<br />
4.7<br />
4.8<br />
4.9<br />
UPS<br />
4.10<br />
4.11<br />
4.12<br />
Alarms<br />
Ref.<br />
4.13<br />
UPS<br />
4.14
Change language