Product Overview 2010 - Lokshop

48
LokPilot Digital Sets
LokPilot digital sets
To simplify conversion of your Delta® locos as much as possible,
the LokPilot digital set is available: It contains a LokPilot
V3.0 decoder 52610, an appropriate permanent magnet and 2
choke coils. You do not need to buy every single item: benefit
from the price advantage of the whole set.
Conversion is simple - you can easily do it yourself!
Here we show you, how it works:
1
We start with a locomotive equipped with a
Delta® motor.
3
Remove the two screws at the motor bearing
assembly and carefully lift off the assembly.
Take care not to lose the coal brushes and
retainer springs!
5
Carefully replace the bearing assembly again:
Wiggle the brushes a bit or gently pull them
apart, so that you can mount the bearing assembly
over the commutator.
2
Universal motor with connected Delta® decoder:
Remove all wires betw. motor and decoder.
Remove all choke-coils and -capacitors
except the one between the motor leads.
4
Pull off the universal field coil and replace it
with the appropriate permanent magnet.
6
+ +
One of 3 magnets is included in each set
Solder one end of a choke coil to each motor
terminal and connect the other end to the
grey, resp. orange wire of the LokPilot/Lok-
Sound decoder. Conversion is done!
Ordering information
52630 LokPilot digital set 1, with LokPilot V3.0 52610, permanent magnet 51960, choke coils
52631 LokPilot digital set 2, with LokPilot V3.0 52610, permanent magnet 51961, choke coils
52632 LokPilot digital set 3, with LokPilot V3.0 52610, permanent magnet 51962, choke coils