Product Overview 2010 - Lokshop

More documents

Recommendations

Info

60 Accessories Change over of skis Dünne Kabel Change over of skis 21MTC adapter board 21 MTC adapter board 21MTC adapter board 2 21MTC adapter board 2 Many railcars are equipped with a ski at both ends. In order to function correctly in block sections, and timely braking in front of red signals, it is vital for the decoder to employ only one ski for (voltage) pick up – depending on direction of travel. To achieve this is precisely the responsibility of our ski changeover electronics: It is hooked up between pick up and a 21TMC connector of a LokPilot- or LokSound V3.5 decoder. After reprogramming, all ESU decoders (not LokPilot Basic V1.0) can send a control-pulse that talks to the change-over electronics and then selects the “correct” ski. This combination works perfectly and without interference in digital – and analog mode. The 21 MTC adapter board is suitable for digitizing a loco without interface and for the case you do not intend to wire the decoder freely. The adapter board offers a possibility for installing a decoder with 21MTC connector. This decoder is simply plugged onto the board. At the other end 21 annular rings make a clean wiring of your loco possible. A neat conversion can be made via this adapter board and enables you to use all additional functions of the 21MTC connector (e.g. loud speaker outputs). The 21 MTC adapter board 2 is also suitable for digitizing a loco without interface. It is very helpful, if you do not intend to wire the decoder freely or if you wish to use more than four function outputs on your LokPilot or LokSound decoder. This adapter board simulates the typcial size and shape of Märklin® 6090xdecoders and can be installed in every suitable position. Decoders with 21MTC connectors (ESU LokPilot or LokSound favoured) are simply plugged onto the adapter board. On the output side, the adapter offers already soldered cables (appr. 20cm length) for all contacts needed. Thus the wiring of your loco is child´s play. There are amplifiers (appr. 250mA each) for function AUX3 and AUX4 (the decoder´s logical outputs) so that ESU decoders have up to 6 available physical function outputs. Ordering information 51966 Ski change-over electronics for use with LokSound V3.5 /LokPilot V3.0 decoders with 21MTC connector 51967 21MTC adapter board 51968 21MTC adapter board 2, shape of 6090x, with AUX3 and AUX4
LokSound XL V3.0 M4 LokSound XL V3.5 LokSound micro V3.5 LokSound V3.0 M4 LokSound V3.5 LokPilot XL V3.0 LokPilot micro V3.0 DCC LokPilot micro V3.0 LokPilot V3.0 DCC LokPilot V3.0 LokPilot V3.0 M4 LokPilot Fx micro V3.0 LokPilot Fx V3.0 LokPilot Basic V1.0 ESU Decoder comparison chart Operational modes DCC 14, 28, 128 speed steps OK OK OK - OK OK OK OK OK OK - OK OK - DCC short addresses OK OK OK - OK OK OK OK OK OK - OK OK - DCC long addresses OK OK OK - OK OK OK OK OK OK - OK OK - DCC consist Mode - OK OK - OK OK OK OK OK OK - OK OK - DCC LGB pulse control - OK OK - OK OK OK OK OK OK - OK OK - automatic speed step detection - OK OK - OK OK OK OK OK OK - OK OK - Lenz LG 100, ROCO brake unit OK OK OK - OK OK OK OK OK OK - OK OK - ZIMO HLU-commands - OK - - OK OK - OK OK - - OK - - DC analog mode OK OK OK - OK OK OK OK OK OK - OK OK - Motorola® 14 speed steps - OK OK OK OK - OK - OK OK OK OK OK OK Motorola® 28 speed steps - OK OK OK OK OK OK - OK OK OK - OK OK Motorola® address 1 - 80 - OK OK OK OK - OK - OK OK OK OK OK OK Motorola® address 1 - 127 - OK OK OK OK - OK - OK OK OK OK OK OK Motorola® address 1 - 255 - - - OK OK - - - OK - OK - - OK Märklin® brake unit - OK OK OK OK - OK - OK OK OK OK OK OK Selectrix® - OK OK - OK - OK - - - - OK - - AC analog mode - OK - OK OK - - - OK OK OK - OK OK Automatic detection of operational mode OK OK OK OK OK OK OK OK OK OK OK OK OK OK Throttle DC and coreless motors AC motors with permanent magnet OK - - OK OK OK OK OK OK OK OK OK OK OK PWM frequency 31.25 kHz - - 32.00 kHz 32.00 kHz 32.00kHz 32.00 kHz 32.00 kHz 32.00 kHz 32.00 kHz 32.00 kHz 32.00 kHz 32.00 kHz 32.00 kHz Load control in digital mode OK - - OK OK OK OK OK OK OK OK OK OK OK Load control in analog mode - - - - OK OK OK OK OK OK - OK OK OK Einstellb. Anfahr- & Höchstgeschw. im Analogbetrieb - - - OK OK OK OK OK OK OK OK OK OK OK Massensimulation für 14 Fahrstufenbetrieb - - - OK OK OK OK OK OK OK OK OK OK OK DDC (Dynamic Drive Control) - - - - OK OK OK OK OK OK - OK OK OK Continuous motor current 0.7A - - 1.1A 1.1A 1.1A 0.75A 0.75A 3.0A 1.1A 1.1A 0.5A 3.0A 3.0A Short circuit protection OK - - OK OK OK OK OK OK OK OK OK OK OK Function outputs Number of function outputs 3 6 4 4 4 4 2 2 8 4 4 4 8 6 Current of each output 180mA 250mA 140mA 250mA 250mA 250mA 140mA 140mA 600mA 250mA 250mA 180mA 600mA 600mA Short circuit protection OK OK OK OK OK OK OK OK OK OK OK OK OK OK Brightness control for outputs combined separate separate separate separate separate separate separate separate separate separate separate separate separate Light effects like Blinking lights, Strobe, Gyra light, Mars light, zoom, Firebox flickering, Ditch light - OK OK OK OK OK OK OK OK OK OK OK OK OK Timer-controlled function outputs - OK OK - OK OK OK OK OK - - - - - Function Mapping acc. to NMRA (F0 to F8) - - - - - - - - - - - - - - Function Mapping acc. to ESU (F0 to F15) - OK OK - OK OK OK (F12) OK (F12) OK OK - OK OK - Function Mapping M4 with icon assignment - - - OK - - - - - - OK - - OK Switcher mode (de-selectable) OK - - OK OK OK OK OK OK OK OK OK OK OK ABV de-selectable OK - - OK OK OK OK OK OK OK OK OK OK OK Sound Polyphonic 4-channel sound - - - - - - - - - OK OK OK OK OK Flash memory for sound data - - - - - - - - - 16 MBit 16 Mbit 16 Mbit 16 Mbit 16 Mbit Power of BTL amplifier (sinus) - - - - - - - - - 0.6W 0.6W 0.5W 1.5W 1.5W Programming DCC service mode programming modes (Register Mode, Address Only, Direct Mode) OK OK OK - OK OK OK OK OK OK - OK OK - DCC POM (Programming On the Main) - OK OK - OK OK OK OK OK OK - OK OK - Programmng mode for Märklin® 6021® - OK OK OK OK - OK OK - OK OK OK OK OK M4 configuration on the main track - - - OK - - - - - - OK - - OK Specials M4 feedback system - - - OK - - - - - - OK - - OK RailCom® feedback system - OK OK - OK OK - OK OK - - - - - Storage of current operational state (memory) - - - OK OK OK OK OK OK OK OK OK OK OK Motorola® wrong-direction bit - OK OK OK OK - OK - OK OK OK OK OK OK Construction Dimensions in mm 25.5x15.5x4.5 17.5x15.5x5.5 13.5x9.0x3.0 23.0x15.5x5.5 23.0x15.5x5.5 13.5x9.0x4.5 13.5x9.0x4.5 13.5x9.0x3.0 55.0x25.0x10 31.0x15.5x6.5 31.0x15.5x6.5 28.0x10.0x5.0 51.0x40.0x14.0 51.0x40.0x14.0 8-pin plug NEM652 with cable harness 52690 52620 - 61600 52610 52611 - - - 524xx 624xx - - - 6-pin lpug S NEM651with cable harness - 52624 - 52612 52613 52687 52684 - - - 528xx - - 6-pin plug NEM651 - - - - 52688 52685 - - - - - - 21MTC connector 52692 52621 - 61601 52614 - - - - 52499 62499 - - - Screw terminals - - - - - - 51702 - - - 525xx 62500 61
Page 1 and 2:
2010 Product Overview 2010 1
Page 3 and 4:
Editorial Dear Model Railway Fans,
Page 5 and 6:
u ECoS - Just Play The ECoS 50200 i
Page 7 and 8:
Functions detailed u Run locos The
Page 9 and 10: u Expandibility ECoSControl Radio E
Page 11 and 12: Features and operation u The Naviga
Page 13 and 14: u ECoSlink Terminal ECoSlink Termin
Page 15 and 16: Feedback An ECoSBoost can do more t
Page 17 and 18: u ECoSDetector Extension ECoSDetect
Page 19 and 20: How to switch stationary decoders A
Page 21 and 22: Expandibility Obviously every boost
Page 23 and 24: u SwitchPilot - Do as you please Sw
Page 25 and 26: u u Precision Servo Motor NEW Preci
Page 27 and 28: u LokSound - Digital operation and
Page 29 and 30: Programming The LokSound decoder su
Page 31 and 32: Art.No. Novelty Delivery Descriptio
Page 33 and 34: Safeguard All function outputs and
Page 35 and 36: Technical data LokSound XL V3.5 Ope
Page 37 and 38: u LokSound XL V3.0 LokSound XL V3.0
Page 39 and 40: Art.No. Novelty Delivery Descriptio
Page 41 and 42: u u Conversion sets LokSound XL V3.
Page 43 and 44: u LokPilot - The jewel among decode
Page 45 and 46: u LokPilot V3.0 DCC - Future built-
Page 47 and 48: u LokPilot micro V3.0 and V3.0 DCC
Page 49 and 50: LokPilot digital 21MTC sets Many mo
Page 51 and 52: u LokPilot XL V3.0 LokPilot XL V3.0
Page 53 and 54: u LokPilot Fx micro V3.0 LokPilot F
Page 55 and 56: u Decoder Tester Decoder Tester 5-p
Page 57 and 58: A sound assistent will help you to
Page 59: u Loudspeakers Loudspeakers for gre
Page 63 and 64: u Interior lighting sets by ESU - G
show all

Product Overview 2010 - Lokshop

Create successful ePaper yourself

Delete template?

Save as template?