MS1204 User Manual - BarcodeMuseum.com

Installation
Mounting the Scanner on the Stand
Note: The stand is optional for the MS 1204FZY, MS 2204, MS 2204VHD,
and MS 3204 only.
To mount the scanner on the optional stand:
1. Place the bottom of the scanner on the stand’s scanner mount, aligning the
scanner’s center threaded insert (beneath the scan window) with the center
mounting hole on the front of the stand. The two rear threaded inserts on the
bottom of the scanner will align with the proper mounting holes on the stand.
2. Secure the scanner to the stand using the three screws provided with the stand.
Assembling the Stand
Scanner mount
Mounting holes
Flat areas
1. Unscrew the wingnut
from the bottom of the
one-piece scanner
mount.
2. Fit the bottom of the
neck piece into the
opening on the top of
the stand base.
3. Tighten the wingnut
underneath the base
to secure the cup and
neck piece (see the
note below).
4. Bend the neck to the
desired position for
scanning.
Stand base
Wingnut
Figure 2-4. Assembling the Stand
2-5