MS1204 User Manual - BarcodeMuseum.com

Installation
Mounting the Scanner on the Mounting Bracket
Note: The mounting bracket is optional for the MS 1204FZY, MS 2204,
MS 2204VHD, and MS 3204 only.
The optional mounting bracket kit consists of a scanner bracket, a mounting bracket, and
the hardware required to mount the scanner. The bracket kit accommodates adjustable
angles for optimal positioning of the scanner.
To mount the MiniScan scanner on the bracket, first secure the scanner to the scanner
bracket, then attach the mounting bracket to the wall (see Figure 2-6 on page 2-8):
1. Tilt the scanner bracket forward to access the center scanner mounting hole on the
bracket.
2. Place the bottom of the scanner on the scanner bracket, aligning the scanner’s
center threaded insert (beneath the scan window) with the center mounting hole on
the scanner bracket.
3. Insert one of the screws provided through the mounting hole and into the scanner’s
center threaded insert.
For the MS 1204FZY, MS 2204, and MS 2204VHD, use a #0 Phillips screwdriver;
for the MS 3204, use a #1 Phillips screwdriver.
4. Tilt the scanner bracket in the opposite direction to access the rear scanner
mounting holes (which are aligned with the rear inserts on the bottom of the
scanner), then insert the remaining two screws provided through the two rear
mounting holes and into the scanner’s threaded inserts.
5. Secure the mounting bracket to a flat surface by inserting 1/8” or smaller fasteners
through the surface and into the bracket’s mounting holes. There are four mounting
holes on the bottom of the mounting bracket for horizontal mounting, and six holes
on the side for vertical mounting.
2-7