MS1204 User Manual - BarcodeMuseum.com

Scanning
Scan Angle Selection
The MS 1204FZY and MS 804FZY scanners support two pre-set scan angles (see each
scanner’s technical specifications).
Selecting Scan Angle via SSI
To use SSI to select the scan angle, issue the SSI PARAM_SEND command with the
NUM_SCAN_ANGLE (191) parameter number. This is set to the default angle (182), or can
be set to the alternate angle (181). See the Simple Serial Interface (SSI) Programmer’s
Guide (p/n 72-40451-xx) for more information.
Selecting Scan Angle via Parameter Bar Code
The scan angle can also be set by scanning a parameter bar code (see Scan Angle on page
11-17). Once the parameter bar code is scanned, that scan angle setting is retained.
Operation in Blink Mode
The scan angle during Blink Mode is determined by the scan angle system parameter.
3-5