Technical Service Manual PM2300 Series Liquid Oxygen Reservoir

Removal, disassembly, assembly, Installation & replacement Instructions
(continued)
Figure 116 Figure 117
Figure 118
Installation
7.11.9 Insure that the Wicking Pad is in position around the Containers neck.
7.11.10 Position the Handle Ring on to the EasyMate Reservoir Canister so the Pump-out Port
passes through its clearance hole in the Handle Ring.
7.11.11 Apply one or two drops of Loctite 222MS Thread Locking Compound to the threads of
the 5 retaining studs on the Container.
7.11.12 Install the Handle Ring Retaining Washers.
7.11.13 Position the Container so the Condensation Collection Container slot is towards you.
7.11.14 Install the Grounding cable, if equipped onto the stud just to the left on the
Condensation Collection Container Slot.
7.11.15 Install the Condensation Collection Container as per User manual.
7.11.16 Install the Drip Pan so its drip hole aligns with the Condensation Collection Container.
7.11.17 Install the Manifold Assembly as per section 7.10.
7.11.18 Install the Warming Coil as per section 7.7.
7.11.19 Install the shroud as per section 7.4 for one (1) piece shroud or 7.4a for two (2) piece shroud.
PM2300 Series Liquid Oxygen Reservoir
Technical Service Manual
49