VALVE SET - Hjallerup Maskinforretning A/S
VALVE SET - Hjallerup Maskinforretning A/S
VALVE SET - Hjallerup Maskinforretning A/S
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MOUNTING<br />
Connector for SELECTO<br />
(ENGLISH (104 -157)<br />
Fig.D<br />
Install the bracket (61) for the connector (60) on the<br />
right subframe or on the plate holding the control valve.<br />
Fig.H<br />
Connect the cable from the electric control device to the<br />
connector (60) according to the wiring diagram (the<br />
leaders are marked 1,2,3).<br />
The connector (60) shall be connected to the current<br />
source(12V+) and the earth wire to the tractor body.<br />
WARNING !<br />
Incorrect installation of the cables will destroy the builtin<br />
diodes in the connectors on the valve.<br />
REMARK !! Connect after the tractor safety switch. The<br />
electr. cables are supplied with a fuse (8A) to be fitted<br />
on the leader (+) between the connector and the current<br />
source. Make sure that the connection point is<br />
dimensioned for the power consumption of the valves<br />
(4A).<br />
IN GENERAL<br />
In order to prevent the electr. cables from being<br />
exposed to wear / squeezing it is important to clamp up<br />
the cables after the fitting. Use supplied strap.<br />
D<br />
H<br />
533<br />
104