Amp Editor Owner's Manual - Yamaha Commercial Audio
Amp Editor Owner's Manual - Yamaha Commercial Audio
Amp Editor Owner's Manual - Yamaha Commercial Audio
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 9<br />
Component editor (TXn only)<br />
■ Oscillator<br />
This is a mono-channel oscillator. It generates a sine wave, pink noise, or burst noise.<br />
q<br />
r<br />
e<br />
w<br />
t<br />
q<br />
Section Parameter Range Function<br />
Sine<br />
100Hz, 1kHz,<br />
10kHz, Vari<br />
w Noise Pink, Burst<br />
Wave Form<br />
e Frequency 20Hz–20kHz<br />
Selects the frequency/waveform that will be generated.<br />
You can select only one of the six [Sine] or<br />
[Noise] buttons.<br />
If you selected the Sine wave [Vari] as the Wave<br />
Form, this specifies the frequency of the sine<br />
wave that will be generated.<br />
r<br />
Output<br />
Level -∞–±0dB Specifies the output signal level.<br />
t ON On/Off Switches the oscillator on/off.<br />
● Pink noise<br />
This is a reference signal used for acoustical measurements. Across the frequency band of 20 Hz–20 kHz,<br />
doubling the frequency will halve the energy. The loudness will be the same for each frequency band.<br />
● Burst noise<br />
Pink noise will be output intermittently.<br />
<strong>Amp</strong> <strong>Editor</strong> 162 Owner’s <strong>Manual</strong>
Change language