Norstar-PLUS Modular ICS 4.0 Installer Guide - Wedophones.com ...

Lines / 257
Press CHANGE to select the setting: ShortCO, MediumCO,
LongCO, ShortPBX or LongPBX.
Tips - This setting applies only to lines connected to an
NT7B75GA-93 Loop Start Trunk Cartridge.
When measuring the distance from ICS to CO and ICS to PBX
use 600 ohms as the termination resistance setting.
Signal
Select the signal type for the line. Press CHANGE to select the
setting: WinkStart, Immediate and DelayDial.
Installer password required
Tips - The Signal setting appears on the display only for
E&M or DID lines.
Make sure that this matches the signal type programmed for the
trunk at the other switch.
For E&M and DID lines connected to a DTI, the Immediate
setting does not appear if dial mode for the line is tone.
ANI Number
Select whether the telephone number of the caller will be
collected for this line. The digits can then be displayed on
Norstar telephones as part of Call Display services. Press
CHANGE to select the setting: N (No) or Y (Yes).
Installer password required
Tips - The central office must deliver ANI/DNIS in DTMF
mode.The delivery of ANI/DNIS depends on the network
provider and the services they offer. This setting applies only to
E&M and DID lines.
P0881590 Issue 02
Modular ICS 4.0 Installer Guide