Norstar-PLUS Modular ICS 4.0 Installer Guide - Wedophones.com ...

484 / Glossary
speaker is not a Norstar component and
must be supplied by the customer.
F
feature button: Many Norstar
features are invoked by pressing the
Feature button followed by a feature
code. The feature button is also used to
exit a feature.
Feature Cartridge: A replaceable
cartridge containing the Norstar
features. The Feature Cartridge is
inserted into the ICS.
feature code: A number that is used
to activate a particular feature.
Feature programming:
ƒ•‹
Allows you to program a feature code
onto a memory button.
Forward: See Call Forward.
Full Autohold (on idle line): When
this feature is on, if you select an
available line, and then do something
that selects another line, the first line is
put on hold. Full Autohold is enabled
under Trunk/Line data in Lines
programming.
Full Handsfree: See Handsfree.
G
Ground Start trunk: Ground start
trunks offer the same features as loop
start trunks, but are used when the local
service provider does not support
disconnect supervision for the digital
loop start trunks. By configuring lines as
ground start, the system will be able to
recognize when a call is released at the
far end. Ground start trunks are
provided only by a DTI.
Group Listening:
ƒ°‚¤
A feature that allows you to have others
in your office hear a caller through your
phoneÕs speaker. The caller hears you
only when you speak into the receiver
and cannot hear other people in the
office.
You can cancel Group Listen for the
current call. Group Listen is cancelled
automatically when you hang up the
Group Listen call.
H
Handsfree: ©
A feature you can use to make calls
without using the telephone receiver.
Full Handsfree is activated under
Capabilities in Terminals and Sets
programming. When it is activated, a
Handsfree/Mute button is automatically
assigned to the telephone.
Handsfree (HF) Answerback:
When activated, this feature
automatically turns on the microphone
at a telephone receiving a Voice Call so
that the person receiving the call can
respond without lifting the receiver. It is
activated under Capabilities in
Terminals and Sets programming.
Handsfree/Mute button: See
Handsfree.
Hardware: A section in programming
that shows what equipment has been
installed in the ICS. This section is
accessed by the installer.
headset: A head-mounted or
ear-mounted telephone receiver that is
used instead of the hand-held receiver.
Headsets are not Norstar components
and must be supplied by the customer.
Held (Line) Reminder: A Norstar
telephone rings and displays the
message On hold: LINENAM when an
external call has been placed on hold for
a certain period of time. The Held Line
Reminder feature and Remind delay are
set under Ftr settings in System
programming.
Modular ICS 4.0 Installer Guide P0881590 Issue 02