Installation and Operating Manual System Protection Relay Energy ...
Installation and Operating Manual System Protection Relay Energy ...
Installation and Operating Manual System Protection Relay Energy ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SYSTEM CONFIGURATION AND RELAY STATUS<br />
When the SPR is initially installed, the relay status will display a blank screen since system has<br />
not been configured for your application <strong>and</strong> the relay parameters have not been set up. <strong>Relay</strong><br />
parameter settings will depend upon your configuration.<br />
<strong>System</strong> configuration<br />
All aspects of product operation are defined from this configuration menu. Certain comm<strong>and</strong>s<br />
can be locked by password, <strong>and</strong> be hidden. In some cases, the configuration menu is not even<br />
available. The system configuration parameters consist of<br />
●<br />
<strong>System</strong> Voltage<br />
●<br />
<strong>System</strong> Current (Amps)<br />
●<br />
<strong>System</strong> Type<br />
To check your system configuration, proceed as follows:<br />
Return to the Main Menu by pressing<br />
ESC as required.<br />
Use the DOWN key to highlight POWER<br />
METERING <strong>and</strong> press ENTER.<br />
Use the DOWN button to highlight<br />
SYSTEM CONFIG <strong>and</strong> press ENTER. The<br />
system configuration display will appear<br />
on the screen<br />
The Primary <strong>System</strong> Voltage <strong>and</strong> Primary<br />
<strong>System</strong> Current (Amps) can be set to suit<br />
your usage; <strong>System</strong> Power is calculated<br />
according to these values.<br />
The <strong>System</strong> Type is factory pre-set to 3-<br />
phase 3 wire or 4 wire, <strong>and</strong> can not be<br />
changed.<br />
23
Change language