PERFORMANCE WORK STATEMENT ATCT / BB and TRACON ...

28.0 CONTRACTOR FURNISHED ITEMS AND SERVICES
28.1 GENERAL: Except For those items or services specifically stated to be government
furnished in this Section, the contractor shall furnish everything required to perform this PWS.
28.2 QUALITY STANDARDS: The contractor shall perform all tasks so that once
accomplished, the standards stated in Section C are at an "Acceptable Quality Level" (AQL). The
Contractor will be responsible for correcting all deficiencies.
28.3 EQUIPMENT: The contractor shall furnish all equipment, materials, and tools necessary
to properly perform the work defined in this contract. All equipment shall have bumpers and
guards to prevent marking or scratching of fixtures, furnishings, or building surfaces.
28.4 ELECTRICAL EQUIPMENT: All electrical equipment used by the contractor shall be
UL approved. This equipment must operate using existing building electrical circuits. It shall be
the responsibility of the contractor to prevent the operation or attempted operation of electrical
equipment or combinations of equipment, which require power exceeding the capacity of existing
building electrical circuits.
28.5 SUPPLIES: The contractor shall furnish all necessary compounds, solvents, barrier
paper, tape, paper products, and brushes within the appropriate specifications. Only approved
federal specification chemicals, cleaning compounds and solvents will be used. All chemicals,
cleaning compounds and solvents shall be stenciled as to content and specification. Samples of
materials along with the appropriate MSDS's shall be submitted to the COTR/CO for approval
prior to the commencement of the contract start date and whenever a change occurs. When a
change occurs, the new material will meet or exceed the quality of previously used items.
28.6 STORAGE: The contractor shall furnish and store all expendable material and loose
equipment within designated areas. The government will not be responsible for security of
storage areas. Any loss or damage to contractor equipment and supplies, are solely the
responsibility of the contractor. Suitable containers for storing acids, flammable, etc. with
supplemental MSDS's shall be provided by the contractor.
28.7 MATERIAL SAFETY: The contractor shall submit a schedule of contractor furnished
supplies not later than fifteen (15) days after contract award. The schedule shall include name,
chemical content, and purpose of all supplies to the used The contractor shall also submit
Hazardous Material Identification in the form of Material Safety Data Sheets (MSDS) that will
meet the requirement of 29 CFR 1910.1200(g) and the latest version of Federal Standard No. 313.
The submittal will also include a Material Safety Data Log, which shall be maintained on site and
available for review upon request of the COTR.
28.8 SPECIAL REQUIREMENTS: The contractor shall furnish protective clothing, gloves,
boots, Personnel Protective Equipment, and chemical goggles for employees required under
OSHA.
29.0 SUBMITTALS
12