AmosConnect Installation Guide - Delta Wave Communications Inc.

More documents

Recommendations

Info

Verify the speed displayed in the Maximum speed (bps)' drop-down list corresponds to the COM Port settings of you satellite terminal. Leave all other options at their default value. 22 Press OK Press OK again to return to the Connect screen Now press the Cancel button to close the dial up networking configuration 23 48 – Appendix 2 – Configure a dial up connection within Windows
Appendix 3 - Troubleshooting AmosConnect provides a very cost-effective means of transferring data between two points. However, it is dependent upon volume to achieve maximum cost savings. Batching messages for transmission in a single session will achieve greater cost savings by achieving better compression and sharing the call overhead. Cost savings achieved when sending one or two small messages will be substantial but will not approach the 80-90% possible with better batching and higher volume. On completion of preparing your message you may either exit from the program completely, if messages are to be batched for the most economical communications, or carry out a communications session immediately, if the message is urgent. If you experience problems in connecting to the AmosConnect hub, the following common errors may help to achieve a successful session. Is the satcom activated when you click on the Connect button Check the cabling between the modem, PC and terminal – physically identify that these cables are fully inserted into the equipment and are not loose In the Communications window – do you see any reference to ‘No Dial Tone’ Check cabling between satcom terminal and modem Using MPDS with Fleet/GAN If you will be using MPDS to establish a connection then you may have to configure 'Extra Settings' for the Modem Driver. If you will be establishing a MPDS connection via a Thrane & Thrane, EMS or JRC Fleet/GAN terminal, Select 'Properties' to proceed, Select the 'Advanced' Tab and populate the 'Extra Initialization commands:' field with AT+WS45=4 and Press OK to proceed. If the modem fails to initialise Check cabling between the PC and satcom/modem Is the correct modem/terminal shown in the Device box On Mini-M terminals add +WS45=201 to the modem setup string (Do not insert any spaces.) 49 – Appendix 3 - Troubleshooting
Page 1 and 2: AmosConnect Installation Guide 1 -
Page 3 and 4: Contents Getting Help .............
Page 5 and 6: 2 Getting Started 2.1 Pre-installat
Page 7 and 8: use, use the first available port.
Page 9 and 10: Nera Mini-m To connect a Nera mini-
Page 11 and 12: An ISDN modem for the ISDN connecti
Page 13 and 14: That completes the connection for t
Page 15 and 16: 4 Click on the Complete option then
Page 17 and 18: The installation now differs depend
Page 19 and 20: 11 As you do not have a full licens
Page 21 and 22: If you are not using Inmarsat Fleet
Page 23 and 24: You will now be prompted that the c
Page 25 and 26: activate your account. You will do
Page 27 and 28: Now if all the settings are correct
Page 29 and 30: This should take about 5 minutes. A
Page 31 and 32: After the database upgrade is compl
Page 33 and 34: Click on the complete option then c
Page 35 and 36: You now need to select I have a lic
Page 37 and 38: Now enter the gateway password as p
Page 39 and 40: Under the General tab, update the E
Page 41 and 42: , You should select Windows Firewal
Page 43 and 44: Select the 'COM Port' to which your
Page 45 and 46: Select Connect to the Internet Pres
Page 47: Press Finish to complete the Networ

AmosConnect Installation Guide - Delta Wave Communications Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?