Linear Units

Ordering Keys
Linear Rod Units
WZ60, WZ80
Your Code
1 2 3 4 5 6
Example WZ06S 20 -00 50 -00780 C N
1. Type of unit
WZ06 = WZ60 unit
WZ08 = WZ80 unit
2. Ball screw lead
05 = 5 mm
10 = 10 mm
20 = 20 mm
50 = 50 mm
Note! for ordering of options type EN, ES, KRG, RT and MGK, see accessory index on page 137.
T90, T130
Your Code
. Maximum stroke (S max)
- • • • • • = distance in mm
4. Total length of unit (L tot)
- • • • • = distance in mm
5. Drive shaft configuration
A = shaft without key way
C = shaft with key way
6. Extension tube configuration
N = standard
1 See table below for available combinations
of units and screw leads.
1 2 3 4 5 6
Example T09-B 2525 M P 450 S1
1. Type of unit
T09-B = T90 unit
T13-B = T130 unit
2. Ball screw diameter, lead and tolerance class
2505 = 25 mm, 05 mm, T7 (only possible for T09-B)
2510 = 25 mm, 10 mm, T7 (only possible for T09-B)
2525 = 25 mm, 25 mm, T7 (only possible for T09-B)
3220 = 32 mm, 20 mm, T7 (only possible for T09-B)
3232 = 32 mm, 32 mm, T7 (only possible for T09-B)
4010 = 40 mm, 10 mm, T7 (only possible for T13-B)
4020 = 40 mm, 20 mm, T7 (only possible for T13-B)
4040 = 40 mm, 40 mm, T7 (only possible for T13-B)
. Engineering unit
M = metric
4. Type of adapter
N = M16 × 1,5 outside thread (only possible for T09-B25 • •)
P = M16 × 2 inside thread (only possible for T09-B25 • •)
Q = M20 × 1,5 outside thread (only possible for T09-B32 • •)
R = M20 × 1,5 inside thread (only possible for T09-B32 • •)
S = M27 × 2 outside thread (only possible for T13-B • •)
T = M27 × 2 inside thread (only possible for T13-B • •)
U = M33 × 2 outside thread (only possible for T13-B • •)
V = M33 × 2 inside thread (only possible for T13-B • •)
X = M30 × 2 inside thread (only possible for T13-B • •)
5. Ordering length (L order)
• • • = distance in cm
6. Protection option 1
S1 = wash down protection
1 Leave blank if no protection option required.
Available screw leads [mm]
Type of unit
5 10 20 50
WZ06 x x x
WZ08 x x x x
218 www.danahermotion.com