Instrumentation & Controls - Siemens

TXP Process Control System
TXP Process Control System
Static Frequency Converter
Static Excitation System
SFC/SES
5 days - $3,300.00
This special course is
scheduled as needed.
Prerequisites
Power plant operator or competent individual with
a background in operating power plants. Prior
completion of Hardware Configuration/Maintenance
(TXP-HW) is highly recommended.
Description
This course will cover the theory and operation of
the SFC/SES control unit used for the start up of gas
turbines and excitation of the generator. Students
will learn about the operation and maintenance
procedures with hands on labs using a Simadyn
D control unit.
Objectives
Upon successful completion of this course, the
student has been trained to:
• Understand the equipment arrangement
• Interpret the electrical schematic diagrams
for the generator excitation
• Identify the limits imposed by software
• Understand the system functionality
• Investigate the sequences involved in start up
• Read the system schematic and software diagrams
• Analyze hardware and software faults
• Carry out routine system maintenance
Course contents
A. Introduction to plant set-up
B. Power section SES
C. Generator diagrams
D. SFC functionality
E. Modes of SFC operation
F. Hardware description
G. Interpreting schematic and software diagrams
H. Fault detection
I. Routine maintenance
J. Use of OP1 interface module
26
www.sea.siemens.com/sitrain