ipc-a-610 âacceptability of electronic assembliesâ - SMTA

More documents

Recommendations

Info

D-PAK Section 8.2.14 CONT. Defect – Class 1,2,3 ♦ Side overhang of thermal plane termination is greater than 25% of termination width. ♦ End of thermal plane termination overhangs land. ♦ End joint width of the thermal plane end termination has less than 100% wetting to land in the contact area.
SECTION 9 – COMPONENT DAMAGE (New Section) 9.5 Connectors: ♦ These criteria cover the plastic molded housings/shrouds which are used primarily as a guide for the mating connector.
Page 1 and 2: IPC-A-610 “ACCEPTABILITY OF ELECT
Page 3 and 4: TRAINING PROGRAM CERTIFIED IPC TRAI
Page 5 and 6: SECTIONS RE-NUMBER ♦ Section 1 -
Page 7 and 8: NEW FORMAT CONT. ♦ 6.10 Terminals
Page 9 and 10: SECTION 6 - TERMINALS CONT. ♦ Cri
Page 11 and 12: NEW SECTION ♦ 5 Soldering ♦ 5.1
Page 13 and 14: WHAT TO EXPECT ♦ TABLES LIKE J-ST
Page 15 and 16: WHAT TO EXPECT CONT. ♦ Example of
Page 17 and 18: WHAT TO EXPECT CONT. ♦ Section 5
Page 19 and 20: ADDITIONAL CRITERIA ♦ PQFN ♦ BG
Page 21 and 22: BGA CRITERIA CONT. ♦ 8.2.12.5 Pla
Page 23 and 24: PLASTIC QUAD FLAT PACK - NO LEADS (
Page 25: D-PAK Section 8.2.14 CONT. Target -
Page 29 and 30: 9.5 CONNECTORS CONT. Defect - Class
Page 31: IPC-A-610 REVISION “D” WORKSHOP

ipc-a-610 âacceptability of electronic assembliesâ - SMTA

Create successful ePaper yourself

Delete template?

Save as template?

ipc-a-610 âacceptability of electronic assembliesâ - SMTA