suzo-happ group

204
tools
SENCORE CM2125 COMPUTER MONITOR
ANALYZER
• Completely Test And
Troubleshoot High
ResolutionAnd Multi-Scan
Computer Monitors From
The Input Connector To
The CRT!
• A complete, easy-to-use,
high resolution computer
monitor analyzer
• Special sync-locked signal
substitutor for pinpointing
monitor circuit problems
• Innovative performance pattern generator
• Patented “ringer” and HV multiplier tester that finds defective:
- yokes
- integrated high voltage transformers (IHVT)
- switching transformers
• Integrated 2,000 volt DCV and PPV meter eliminates the need for
a DVM for complete one-unit troubleshooting
• A fully programmable scan frequency and pixel resolution RGB
video generator
- bandwidth to 125 MHz and 2048 x 2048 pixels
- compatible with TTL, analog, and ECL video types
- 70 monitor setup memory locations (43 preprogrammed)
- outputs protected to prevent damage from defective
computer monitors
• “Hook-up” adapters available
Part Number Description
92-0303-00 Sencore CM2125 Computer Monitor Analyzer
SENCORE HA325 HORIZONTAL OUTPUT
& FLYBACK TESTER
• With one simple hookup,
the HA325 quickly identifies
what is working and what
isn’t, without a schematic
on any CRT based display
• Automatically analyzes the
horizontal output circuits
and tells you if they are
good or bad and suggests
the parts you need to test
and repair on the display
• Improves the skill of your
service technicians for
faster more efficient
repairs. Find the horizontal
output transistor or IHVT
(high voltage transformer),
hook up the leads and the
HA 325 automatically
makes the analysis
• Cuts down on replacement repair costs. Replacing parts that
aren’t bad can be very expensive especially when parts have to be
ordered and the game remains down while parts are on order
• The HA325 helps you to quickly and accurately determine
defective parts in the horizontal output circuits
SENCORE LC103 REZOLVER IN-CIRCUIT
CAPACITOR AND INDUCTOR ANALYZER
• Automatically tells you when
further out-of-circuit tests
are required.
• Tests SMT components
“in-circuit” and accurately
with exclusive, time-saving
test accessories
• Makes all tests, compares
the results to EIA standards,
and tells you “GOOD” or
“BAD” – automatically
• Analyzes capacitors for all
four failures out-of-circuit:
- Value from 1 pF to 20 F
- Equivalent series resistance
- Dielectric absorption
- Leakage with up to 1,000 volts
• Analys inductors with exclusive patented tests for:
- Values from 0.1 uH to 20 H
- Opens or shorts
- Even one shorted turn with patented “Ringer” test
• Tests SCRs and triacs with optional SCR250 accessory
LC103 Condensed Specifications - In-Circuit Tests (Capacitors & Inductors):
Dynamic in-circuit tests to determine whether the component is good or bad.
Electrolytic, double layer lytic, tantalum, ceramic, and
Component Types other capacitors; Yokes, flybacks, switching transformers,
and coils
Inductor Range 3.18 uH to 3.18 H
Capacitor Range 0.002 uF to 20,000 uF
Accuracy
Same as Out-of-Circuit tests for known good inductors and
capacitors with no parallel current paths
Suggest Removal
Initiated when AC test differs from DC test by more than
Indication
20%, or if low level DCR test indicates a leakage path
greater than 20% of charge current for capacitors.
Part Number Description
92-0300-00 Sencore LC103 Rezolver In-Circuit
Part Number Description
92-0314-00 Sencore HA325 Horizontal Output & Flyback Tester
Call 888-289-4277 to Order
2009/2010