CSD5 Servo Drive

3-6 Wiring
Using the Socket and Lever
This section describes the usage of wiring socket and lever provided
with servo drive.
• Connect only one wire at wire inlet of the socket.
• If the wire is pulled accidentally with an excessive force, rewire it
properly.
• The peeled wire can be used. (Keep the length of the peeled core wire
less than 8 [mm].)
• The use of phenol terminal is recommended for the reliability of wiring.
• Use a lever for wires provided with the product.
The following figure shows the sequence of assembling wire at the
socket.
1. As shown in the figure, insert lever in the socket and press it.
2. Insert wire into socket and release the lever.
3. Pull it slightly to check if the connection between the socket and wire is
normal.
Prepare the Wires Strip of the Phenol Terminial Assemble the Socket
+
Wire
Terminal
Comress with the Phenol
Terminal Compressor
NOTE: Keep the length of the peeled wire less than 8
Socke
Lever
The thickness of wire allowed by the socket is shown below.
Thickness of Wire
Twist
AWG20 ~ AWG14
CSD5 Servo Drive