W1683 Manual - Grizzly Industrial Inc.
W1683 Manual - Grizzly Industrial Inc.
W1683 Manual - Grizzly Industrial Inc.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Moving Bed Rollers<br />
In order to perform table adjustments, the bed<br />
rollers must be adjusted below the surface of<br />
the table.<br />
To move the bed rollers:<br />
1. Loosen the setscrews where the bed rollers<br />
mount to the planer body (on both ends) as<br />
shown in Figure 9.<br />
2. Use a wrench to lower the rollers on their<br />
eccentric shafts.<br />
Leave the bed rollers in this position until<br />
instructed to adjust them at the end of this<br />
section.<br />
Figure 9. Bed roller setscrews.<br />
ADJUSTMENTS<br />
Table<br />
The most critical adjustments made on your new<br />
planer are dependent on the table being<br />
parallel to the cutterhead body. Because of this<br />
relationship, checking the table is the first step<br />
to setting up an accurate planer.<br />
There are two movements you should be<br />
concerned about when checking/adjusting the<br />
table—the table should be parallel to the head<br />
casting from front-to-back, and the table should<br />
be parallel with the cutterhead body from sideto-side.<br />
Side View<br />
Front View<br />
Figure 10. Gauge block.<br />
The table has been pre-set at the factory, but it<br />
is a good idea to check any machine thoroughly<br />
before use.<br />
To check the table:<br />
1. Make sure machine is unplugged!<br />
2. Make the gauge shown in Figure 10 out of a<br />
block of wood.<br />
14