Develop a time stamping application in PlantStruxure? - Schneider ...

More documents

Recommendations

Info

4-Configuration 4.2. Time stamped by program There are three parts to configure for the time stamped by program method; the time reference device, PAC and SCADA. The example is implemented according to solution #3, refer to Table 3. • Time reference device There are two parts to the time reference configuration, the GPS receiver setup and the time synchronization setup. Set up GPS receiver: Step Action 1 Put the GPS receiver module into the BBS-3 GPS and connect antenna. 2 Check if the synchronization is correct. Set up time synchronization module (NTP server): Step Action 1 Put the NTP server module into the BBS-3 GPS and connect it to the network for network time synchronization. 2 Set up the NTP server. For example, NTP server IP address is 192.168.0.6 Run the dnts3.exe with the following command to set up the NTP server IP address: “dnts3 –s 192.168.0.6 255.255.255.0 00-03-b9-a9-0b-9b” 44
4-Configuration • PAC Set the NOE module (NTP Client): Step Action 1 Set up NTP client IP address For example: NTP client IP address is 192.168.0.31 2 Set up the NTP client in the web page. 3 Log on the web server, and set up the NTP client. 45
Page 1: How can I … Develop a time stampi
Page 4 and 5: The STG Collection System Technical
Page 6 and 7: 6. Operation.......................
Page 8 and 9: 1-Introduction 8
Page 10 and 11: 1-Introduction Figure 1 Time stampi
Page 12 and 13: 1-Introduction 1.3. Challenges Figu
Page 14 and 15: 2-Selection 14
Page 16 and 17: 2-Selection Figure 3 Time stamping
Page 18 and 19: 2-Selection Table 3 Solution list f
Page 20 and 21: 3-Design 20
Page 22 and 23: 3-Design Figure 4 System architectu
Page 24 and 25: 3-Design In the Process Engineering
Page 26 and 27: 3-Design Figure 7 shows the program
Page 28 and 29: 3-Design The table below gives para
Page 30 and 31: 3-Design The next table gives param
Page 32 and 33: 3-Design The following table gives
Page 38 and 39: 3-Design For example, the TimeStamp
Page 40 and 41: 3-Design 40
Page 42 and 43: 4-Configuration • PAC configurati
Page 46 and 47: 4-Configuration • SCADA This proc
Page 48 and 49: 5-Implementation NTP mode: Use the
Page 50 and 51: 5-Implementation 5.2. SCADA There a
Page 52 and 53: 5-Implementation 52
Page 54 and 55: 6-Operation 6.2 Time stamping alarm
Page 56 and 57: 7- HPP Example The hydro power cont
Page 58 and 59: 7- HPP Example SCADA can be used to
Page 60 and 61: 7- HPP Example Use this section to
Page 62 and 63: 7- HPP Example The turbine and gene
Page 64 and 65: 7- HPP Example Figure 18 Device Lis
Page 66: Schneider Electric Industries SAS H

Develop a time stamping application in PlantStruxure? - Schneider ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?