2.1.3 Port-based VLAN - VOLKTEK Ethernet & fiber

More documents

Recommendations

Info

1. VLAN Aware mode: Enabled - Strip VLAN tag from received frame and insert VLAN tag in transmitted frame, except ingress frames which’s VID is the same as PVID. Disabled – Default state, switch doesn’t do VLAN tag stripping and inserting. 2. Ingress filtering: Enabled - Check ingress frame VLAN ID. Ingress frame will be dropped if frame's VID is not the same as the VID of the ingress port. Disabled – Don’t do ingress VLAN frame checking, frames will be flood as normal. 3. Accept Packet Type: ALL - Accept all ingress frames Tagged only - Only accept ingress frames with VLAN tag 4. Port VID: Set port VLAN ID for untagged ingress frames. Set "None" for trunk port member. 12
2.1.5 Port Trunking Port Trunking defines how to create a single high-speed logical link that combines several low-speed physical links. By default, all ports were set to normal state. You can group multiple ports to a trunk; up to 4 groups are supported. For example, choose port 1 and port 2 into group 1. After implementation, diagram will show as below. 13
Page 1 and 2: 8-Port Gigabit Web Smart Switch NSH
Page 3 and 4: 1 Introduction The NSH-9308P Switch
Page 5 and 6: 1.2 Start to Manage This Switch Use
Page 7 and 8: 2.1 Configurations 2.1.1 System inf
Page 9 and 10: 2.1.2 Ports Port status page always
Page 11: 2.1.4 Tag-based VLAN Tag-based VLAN
Page 15: 2.1.7 Quality of Service QoS (Quali
Page 18 and 19: 2.1.9 LACP Different from the stati
Page 20 and 21: You can modify the following parame
Page 22 and 23: 2.1.12 802.1x Before you enable the
Page 24 and 25: 2.2 Monitoring 2.2.1. Port Statisti
Page 26 and 27: 2.2.5 IGMP Status Select “IGMP St
Page 28 and 29: 2.3.4 Config File Click “Backup
Page 30 and 31: System Configuration [all] System R

2.1.3 Port-based VLAN - VOLKTEK Ethernet & fiber

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?